- Microstructure and Mechanical Properties of Steels
- High Temperature Alloys and Creep
- Hydrogen embrittlement and corrosion behaviors in metals
- Aquaculture disease management and microbiota
- Ammonia Synthesis and Nitrogen Reduction
- Electrical Fault Detection and Protection
- Microbial Community Ecology and Physiology
- Aluminum Alloys Composites Properties
- Advanced materials and composites
- Wastewater Treatment and Nitrogen Removal
- Composting and Vermicomposting Techniques
- Power Systems Fault Detection
- High voltage insulation and dielectric phenomena
- Entomopathogenic Microorganisms in Pest Control
- Odor and Emission Control Technologies
- Nematode management and characterization studies
- Titanium Alloys Microstructure and Properties
- Gut microbiota and health
- Nuts composition and effects
Thermal Power Research Institute
2019-2023
China Agricultural University
2020-2021
Beijing Institute of Technology
2019
Huazhong Agricultural University
2019
Exposure to gaseous ammonia, even at low levels, can be harmful pigs and human health. However, less is known about the effects of sustained exposure ammonia on nasal microbiota colonization in growing pigs. A total 120 Duroc×Landrace×Yorkshire were housed 24 separate chambers continuously exposed 0,5, 10, 15, 20, 25 ppm (four groups per level) for 4 weeks. Then, we used high-throughput sequencing perform 16S rRNA gene analysis swabs samples from 72 (n = 12). The results showed that an...
The complex structure of gas-insulated switchgear (GIS) cable terminals leads to serious electric field concentration, which is a frequent fault position high-voltage system. At present, due the differences in frequency bands sensors, various partial discharge detection technologies have certain their scope application and anti-interference performance, resulting low defect rate GIS terminals. In this paper, comprehensive diagnosis scheme proposed, integrates transient earth voltage (TEV),...
The microstructural evolution and oxidation behaviour of shot-peened S30432 stainless steel during exposure in steam environment a real double reheat USC power plant has been investigated through characterisation using electron microscopes. results indicated that shot-peening treatment introduced thick deformation layer to the material, this consisted an outer nanostructured inner with bands. During thermal exposure, experienced extensive recrystallisation coarsening, numerous σ particles...
The Laves phase formed during the long-term creep of 9% Cr heat-resistant steels plays an important role in their high-temperature mechanical properties. Detecting and quantifying is one main problems predicting residual life. This study detects quantifies various steel samples by anodic polarization. Both T92/P92 after 9Cr ferritic martensitic thermal ageing precipitate particles, content increases with service time. Comparing results obtained electrochemical method those traditional SEM...