A5101762328- Corrosion Behavior and Inhibition
- Metal-Organic Frameworks: Synthesis and Applications
- Hydrogen embrittlement and corrosion behaviors in metals
- Aluminum Alloy Microstructure Properties
- Microstructure and Mechanical Properties of Steels
- Magnetism in coordination complexes
- Metal Alloys Wear and Properties
- Epoxy Resin Curing Processes
- Advanced Fiber Optic Sensors
- Supercapacitor Materials and Fabrication
- Graphene research and applications
- ZnO doping and properties
- Powder Metallurgy Techniques and Materials
- Mechanical stress and fatigue analysis
- Metal and Thin Film Mechanics
- Advancements in Battery Materials
- Concrete Corrosion and Durability
- Mechanical Failure Analysis and Simulation
- High voltage insulation and dielectric phenomena
- Gas Sensing Nanomaterials and Sensors
- Nonlinear Optical Materials Research
Chinese People's Liberation Army
2024
National University of Defense Technology
2017
Optical properties, which determine the application of optical devices in different fields, are most significant properties thin films. In recent years, Metal-organic framework (MOF)-based films have attracted increasing attention because their novel and important potential applications photoelectric devices, especially with tunable properties. This study reports first example tuning a MOF-based film via post-modification. The was composed NH₂-MIL-53(Al) nanorods (NRs) (MIL: Materials from...
Monitoring of real-time flow and defects in the vacuum-assisted resin infusion (VARI) process can provide important guidelines for full impregnation dry reinforcement. A weak fiber Bragg grating array was employed to obtain quasi-distributed monitoring results real-time. Sensitivity testing different kinds coated optical sensors (OFs) carried out first, polyacrylate-coated OF showed a greater wavelength-shift response than polyimide-coated one. Then, two- three-dimensional tests were out....
Recently, the preparation of flexible graphene-based micro-supercapacitors has attracted considerable attention. In this paper, a and all-solid-state micro-supercapacitor was fabricated by LightScribe technology. Additionally, influences drop-cast amount graphene oxide (GO) numbers times on performance supercapacitor were systematically investigated means cyclic voltammetry, electrochemical impedance spectroscopy, galvanostatic charge/discharge. It determined that optimal when 0.38 mg cm−2....
The corrosion behavior and formation of the product film three 90Cu-10Ni alloys, namely Pipe A, B, C, after being immersed in simulated seawater for different time were investigated using electrochemical techniques, electron backscattered diffraction (EBSD) technology, scanning microscopy/energy-dispersive X-ray detector (SEM/EDS), photoelectron spectroscopy (XPS). results demonstrated that there no obvious differences chemical composition, but some grain size number annealing twins alloys....
A new strategy for the high-throughput characterization of mechanical homogeneity metallurgical materials is proposed. Based on principle hydrostatic transmission and synergistic analysis composition, microstructure, defects, surface profile chosen material, microstrain characteristics changes in roughness after isostatic pressing were analyzed. After pressing, two types microstrains produced: low (surface smoothening with decreasing roughness) large roughening increasing roughness)....
Abstract The bending failure, failure load and mode of thin-walled circular tubes made carbon fiber reinforced resin matrix composites were investigated by experiments numerical simulation. Three typical modes under observed in experiments, the characteristics mechanisms different analyzed. results show that interlaminar shear induces generation propagation microcracks at interface tubes, which accelerates tubes. In process, because interlayer performance round pipe is relatively low, it...