A5020321683- Advancements in Battery Materials
- Advanced Battery Materials and Technologies
- Porphyrin and Phthalocyanine Chemistry
- Conducting polymers and applications
- Advancements in Photolithography Techniques
- Supercapacitor Materials and Fabrication
- Nonlinear Optical Materials Studies
- Advanced Battery Technologies Research
- Integrated Circuits and Semiconductor Failure Analysis
- Fuel Cells and Related Materials
- Electron and X-Ray Spectroscopy Techniques
- Advanced Surface Polishing Techniques
- Photochemistry and Electron Transfer Studies
- Hydrological Forecasting Using AI
- Nonlinear Optical Materials Research
- Electronic Packaging and Soldering Technologies
- Educational Research and Pedagogy
- Semiconductor materials and devices
- Educational Robotics and Engineering
- Optical Coatings and Gratings
- Electrocatalysts for Energy Conversion
- Extraction and Separation Processes
- Engineering Applied Research
- Mesoporous Materials and Catalysis
- Frequency Control in Power Systems
Toyota Central Research and Development Laboratories (Japan)
2010-2024
Aichi Institute of Technology
2007-2022
Kyoto University
2020-2021
Joetsu University of Education
2020-2021
Tech Foundation
2016
Hitachi (Japan)
1996-2015
Toyota Motor Corporation (Switzerland)
2014
Tokyo Metropolitan University
2006-2009
Toyama Prefectural University
2008-2009
Chubu Electric Power (Japan)
2009
LiFePO4 (space group: Pnma) was synthesized by the hydrothermal method at 443 K. The pH of precursor solution systematically changed between 2.5 and 9.5. particle morphology, crystal orientation, electrochemical reactivity prepared particles depending on concentration Li source precursor. obtained from acidic solutions (pH ≈ 3.5) were needle-like particles. On other hand, plate-like crystals weak 4 < 6.5. At higher than 7.2, became randomly shaped. had a large facet in ac-plane, while...
Three dimensionally ordered macroporous (3DOM) carbons with mesoporous walls were prepared by a colloidal crystal templating method. A three composite consisting of monodisperse polystyrene (PS) latex (100–450 nm) and silica (5–50 was an evaporation process suspensions containing PS in water. In the course heat treatment this membrane at 573 K under inert atmosphere, melted penetrated into spaces between silica. The carbonized during further to provide very thin carbon layer on silica,...
A star-shaped copolymer, poly(styrene)-block-poly[poly(ethylene glycol) methyl ethyl methacrylate , was synthesized by the combination of living anionic polymerization styrene and ruthenium-catalyzed radical poly(ethylene ether methacrylate. The prepared copolymer characterized to evaluate its use as a solid polymer electrolyte (SPE) in lithium-ion batteries. star comprised hard, condensed poly(styrene) part at center, which enhanced mechanical properties solid-state polymer, soft, mobile...
Fluoride ion batteries (FIBs) are regarded as promising energy storage devices, and it is important urgent to develop cathode materials with high densities for use in FIBs.
With the increasing development of electric vehicles and portable devices, there is a strong requirement for high-energy batteries. To improve battery energy, multielectron transfer electrode reactions can be applied. Previously, batteries based on fluoride-ion shuttle (F– ion batteries, FiBs) have been reported, utilizing electrodes with reactions. Although these FiBs exhibit high theoretical energy densities, reported capacities are significantly less than values. Moreover,...
Metallic Li deposited on the anode is known to induce short circuiting and degradation of charge capacity Li-ion batteries. However, no reliable technique currently available observe such metal without removing case battery. An elemental analysis using muonic X-rays proposed here because its unique properties nondestructive measurement, high sensitivity light elements, depth resolution. We demonstrated that this can be applied detection surface an containing ions, a fully charged with due...
Coaxial-fibers bundled batteries in which the negative electrode made of carbon fibers, separator and positive are formed this order from inside proposed to be used as a framework power source for future applications.
Abstract A field effect transistor with a PbTiO3 ferroelectric thin film gate has been prepared as an infrared sensor which works at room temperature and sensitivity in wide spectral range. was deposited rf sputtering substrate temperatures of 300–550°C. dielectric constant 200 maximum remanent polarization 27 μC/cm2 were obtained the films on platinum foil. Pyroelectric response platinum-coated mica voltage responsivity Rv detectivity D* 330 V/W 1.5 × 108 cm√Hz/W bandwidth 1 Hz respectively...
A carbon-coated platelike particle (space group: ) was prepared by employing a hydrothermal method at . The obtained had preferred crystal orientation with (020) texture, which revealed transmission electron microscopy and diffraction. After the treatment, further heat-treatments high temperatures were carried out to increase electrical conductivity of carbon layer, considerably improved heat-treatment higher than exhibited high-rate charge–discharge capability in liquid electrolyte...
Developing high-performance solid electrolytes that are operable at room temperature is one of the toughest challenges related to all-solid-state fluoride-ion batteries (FIBs). In this study, tetragonal β-Pb0.78Sn1.22F4, a promising electrolyte material for mild-temperature applications, was modified through annealing under various atmospheres using thin-film models. The annealed samples exhibited preferential growth and enhanced ionic conductivities. rate-determining factor...
In pursuit of high-capacity Mn-based oxides as positive electrode materials for lithium-ion batteries, the changes in charge-discharge curve due to spinel transition still stand way cycling stability. We found this study that Li1.12Mn0.74O1.60F0.40 (LMOF05) electrodes with a loose-crystalline rock salt structure (LCRS), which F is placed near Mn, show stable and high capacity (300 mA h g-1, 952 W kg-1) little change curve. demonstrated by K-edge soft X-ray absorption spectroscopy diffraction...
Bimodal porous carbons consisting of interconnected macropores and spherical mesopores, were prepared by colloidal crystal templating method. The template was evaporation process suspensions containing monodisperse poly[styrene-(co-2-hydroxyethyl methacrylate)] (PSHEMA) latex silica in water. carbonization PSHEMA at 1000°C under inert atmosphere provided very thin carbon layer on the template, macropore corresponding to particle size formed simultaneously. After this procedure, bimodal...
Changes in chemical nature of an ArF photoresist caused by various plasmas were analyzed, and it was found that the HBr plasma treatment induces a selective detachment heterocyclic unit photoresist, detached remains film. Thermomechanical analyses performed, which showed softening temperature decreases treatment, indicating acts as plasticizer These results can be regarded process photoresist. This applied to fabrication line patterns shown remarkably improves LWR (line width roughness)...
This paper describes a method to enhance the load frequency control in power system with distributed generations (DG). In this paper, storage is used solar photovoltaic and wind generations. The microgrid at Aichi Institute Technology Japan as simulation model. For each simulation, which was carried out by using transmission simulator, model of included one DG system. effectiveness examined. It confirmed that electric quality improves when