A5027810222- Hydrogen embrittlement and corrosion behaviors in metals
- Corrosion Behavior and Inhibition
- Welding Techniques and Residual Stresses
- Structural Integrity and Reliability Analysis
- Concrete Corrosion and Durability
- Non-Destructive Testing Techniques
- Metallurgy and Material Forming
- Titanium Alloys Microstructure and Properties
- Fatigue and fracture mechanics
- Lung Cancer Treatments and Mutations
- Additive Manufacturing Materials and Processes
- Material Properties and Failure Mechanisms
- Geotechnical Engineering and Underground Structures
- Advanced materials and composites
- Carbon Nanotubes in Composites
- Advanced Sensor and Energy Harvesting Materials
- Metal Alloys Wear and Properties
- Metal and Thin Film Mechanics
- Microstructure and Mechanical Properties of Steels
- Advanced Surface Polishing Techniques
- Electrodeposition and Electroless Coatings
- Energetic Materials and Combustion
- Erosion and Abrasive Machining
- Aluminum Alloy Microstructure Properties
- Polymer Nanocomposites and Properties
China National Petroleum Corporation (China)
2011-2025
State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation
2025
Sichuan University
2011-2025
Curtin University
2016-2024
Chongqing University
2016-2024
Shaanxi Yanchang Petroleum (China)
2024
Shaanxi Research Design Institute of Petroleum and Chemical Industry
2024
Nanyang Normal University
2024
West China Hospital of Sichuan University
2022-2024
Tianjin Normal University
2024
We herein provide an effective method to fabricate a transparent superamphiphobic coating with superhydrophobicity and near-superoleophobicity, the finished also shows improved stability under various measurements. To do this, superhydrophobic was first prepared polydimethylsiloxane (PDMS) hydrophobic silicon dioxide (SiO2) nanoparticles. Then sintered degrade PDMS into SiO2 before it further oxidized silanol (Si–OH). Finally, treated 1H, 2H, 2H-Perfluorooctyl-trichlorosilane (PFTS). The...
Electrochemically formed passive film on titanium in 1.0 M H2SO4 solution and its thickness, composition, chemical state, local fine structure are examined by Auger electron spectroscopy (AES), X-ray photoelectron (XPS), absorption structure. AES analysis reveals that the thickness composition of oxide proportional to reciprocal current density potentiodynamic polarization. XPS depth profiles states exhibit coexistence various valences cations surface. Quantitative near edge electronic...
Abstract In this article, polypropylene (PP)/multiwall carbon nanotubes (MWNTs) composites were prepared through dynamic packing injection molding, in which the oscillatory shear was exerted on molten composite during and solidification stage of injection‐molding. A simultaneous increase tensile strength impact has been achieved for PP/MWNTs containing only 0.6 wt % MWNTs. Particularly, found increased by almost 50% at such low MWNTs content. These improvements properties attributed to...
Abstract The China Spallation Neutron Source (CSNS), operational since 2018, is upgrading to CSNS-II, increasing the proton beam power 500 kW and requiring advancements in detector technology readout electronics. This paper summarizes current state of electronics at CSNS outlines challenges posed by CSNS-II upgrade, including higher neutron flux, vacuum operation requirements, demands for spatial resolution. We present development low-power suitable environments, such as customized ASIC...
In recent years, China's natural gas industry has developed very rapidly, and its utilization scope use areas have gradually expanded. A lot of station yards been built all over the country. The girth weld compressor inlet outlet pipeline in affected by high pressure vibration fatigue for a long time during service, which is weak link pipeline. this paper, through field investigation 4 stations 14 units along pipeline, 106 welds area are identified. structural characteristics near multiple...
Heart failure (HF) complicated by acute kidney injury (AKI) significantly impacts patient outcomes, and it is crucial to make early predictions of short-term mortality. This study focused on developing an interpretable machine learning model enhance prediction accuracy in such clinical scenarios. retrospective cohort utilized data from the Medical Information Mart for Intensive Care Ⅳ (MIMIC-Ⅳ, version 2.0) database. Data first 24 hours after admission ICU were extracted divided into a...
Highly pure membranes of double–walled carbon nanotubes (DWCNTs; see figure) have been prepared by combining a purification process with the competition characteristics water and ethanol interactions surface CNTs. The resulting ultrathin films consist single layer CNTs they show an enhanced tensile strength. method can also easily be expanded to other types nanotubes. Supporting information for this article is available on WWW under http://www.wiley-vch.de/contents/jc_2089/2006/c1841_s.pdf...
At present, polyethylene pipeline is widely used in urban gas projects, but a relatively mature and reliable nondestructive testing technology has not been formed. Therefore, it urgent to develop new meet the increasing demand for inspection of non-metallic pipes. The terahertz related equipment have played an increasingly important role many nonmetallic structures, they applied (PE) In this work, time-domain spectroscopy was detect prefabricated defects inside PE pipe specimens. results...