A5017334626- Radiation Effects and Dosimetry
- Advanced materials and composites
- Nuclear Physics and Applications
- Surface Treatment and Coatings
- Metal and Thin Film Mechanics
- Titanium Alloys Microstructure and Properties
- High-Temperature Coating Behaviors
- Metal Alloys Wear and Properties
- Material Properties and Applications
- Additive Manufacturing Materials and Processes
- High Entropy Alloys Studies
- Advanced ceramic materials synthesis
- Radiation Detection and Scintillator Technologies
- Bone Tissue Engineering Materials
- Intermetallics and Advanced Alloy Properties
- Radiation Shielding Materials Analysis
- Radioactivity and Radon Measurements
- Engineering and Environmental Studies
- Additive Manufacturing and 3D Printing Technologies
- Heat Transfer and Boiling Studies
- Radiation Dose and Imaging
- Aluminum Alloys Composites Properties
- Orthopaedic implants and arthroplasty
- Material Properties and Failure Mechanisms
- Diamond and Carbon-based Materials Research
Baikov Institute of Metallurgy and Materials Science
2015-2024
Bauman Moscow State Technical University
2024
Medical Radiological Research Center
2007-2022
Ministry of Health of the Russian Federation
2020-2022
Institute of Metallurgy and Materials Science
2021
Institute of Metallurgy
2021
Moscow State Technological University
2019
Lomonosov Moscow State University
2019
University of Technology
2019
Volgograd State Technical University
2009-2017
The paper considers silver alloying effect on stainless steel microhardness. Microhardness decreases while the mass fraction of in composition increases.
Journal Article The Third International Intercomparison on EPR Tooth Dosimetry: part 2, final analysis Get access A. Wieser, Wieser *Corresponding author: wieser@gsf.de Search for other works by this author on: Oxford Academic PubMed Google Scholar R. Debuyst, Debuyst P. Fattibene, Fattibene Meghzifene, Meghzifene S. Onori, Onori N. Bayankin, Bayankin Brik, Brik Bugay, Bugay V. Chumak, Chumak B. Ciesielski, Ciesielski ... Show more M. Hoshi, Hoshi H. Imata, Imata Ivannikov, Ivannikov D....
The method of electron paramagnetic resonance (EPR) dosimetry was applied to the enamel teeth extracted from residents Dolon and Bodene settlements Beskaragay district, which is area adjacent radioactive fallout most contaminating nuclear test 1949. individual accidental radiation doses due were obtained amplitude induced EPR signal CO2- radical using calibration method, after determining parameters measurements obtain best reproducibility intensities. It shown that subtracting natural...
The method of electron paramagnetic resonance (EPR) spectroscopy for tooth enamel is applied to individual radiation dose determination residents two villages (Dolon and Mostik) in the vicinity Semipalatinsk nuclear test site Kazakhstan. These are located near central axis radioactive fallout trace most contaminating surface conducted 1949. It found that excess doses obtained by subtraction natural background from absorbed range up 440 mGy Dolon, whose was formed before 1949, do not exceed...
This review discusses the main methods for producing spherical powder particles of corrosion-resistant steels as a material widely used in all industries. Also examples products made by modern additive are described. Currently, following methods: selective laser melting, sintering, direct and electron beam melting. Each these has its own requirements characteristics steels. The provides brief description principles operation each method It also considers detailed manufacturing with principle...
In order to improve the accuracy of tooth enamel EPR dosimetry method, spectra recording conditions were optimized. The uncertainty dose determination was obtained as mean square deviation doses, determined with use a deconvolution program, from nominal doses for ten samples irradiated in range 0 500 mGy. recorded at different microwave powers and accumulation times. It shown that minimal is achieved power about 2 mW used spectrometer JEOL JES-FA100. found limit time exists beyond which...
A tooth enamel electron spin resonance (ESR) dosimetry study was carried out with the purpose of obtaining individual absorbed radiation doses population from settlements in Semipalatinsk region Kazakhstan, which exposed to radioactive fallout traces nuclear explosions Nuclear Test Site and Lop Nor test base, China. Most are located near central axis trace most contaminating surface test, conducted on 29 August 1949, maximum detected excess dose being 430 ± 93 mGy. 268 79 mGy determined...