- Advanced Multi-Objective Optimization Algorithms
- Gaussian Processes and Bayesian Inference
- Turbomachinery Performance and Optimization
- Optimal Experimental Design Methods
- Antenna Design and Analysis
- Model Reduction and Neural Networks
- Metaheuristic Optimization Algorithms Research
- Probabilistic and Robust Engineering Design
- Machine Learning and Data Classification
- Fault Detection and Control Systems
- Antenna Design and Optimization
- Machine Fault Diagnosis Techniques
- Target Tracking and Data Fusion in Sensor Networks
- Fluid Dynamics and Turbulent Flows
- Aluminum Alloy Microstructure Properties
- Advanced Antenna and Metasurface Technologies
- Manufacturing Process and Optimization
- Face and Expression Recognition
- Rough Sets and Fuzzy Logic
- Time Series Analysis and Forecasting
- Advanced Computational Techniques and Applications
- Space Satellite Systems and Control
- Heat Transfer Mechanisms
- Microwave Engineering and Waveguides
- Infrared Target Detection Methodologies
Shanghai Jiao Tong University
2008-2025
Shanghai First People's Hospital
2022-2025
National Defence University
2025
Shanghai Key Laboratory of Trustworthy Computing
2024
East China Normal University
2024
Dalian University of Technology
2014-2024
Huainan Normal University
2024
Henan University of Science and Technology
2023-2024
East China Jiaotong University
2020-2023
Civil Aviation University of China
2023
Surrogate models are widely used in simulation-based engineering design and optimization to save the computing cost. The choice of sampling approach has a great impact on metamodel accuracy. This article presents robust error-pursuing sequential called cross-validation (CV)-Voronoi for global metamodeling. During process, CV-Voronoi uses Voronoi diagram partition space into set cells according existing points. error behavior each cell is estimated by leave-one-out (LOO) approach. Large...
In dealing with the expensive multiobjective optimization problem, some algorithms convert it into a number of single-objective subproblems for optimization. At each iteration, these conduct surrogate-assisted on one or multiple subproblems. However, may be unnecessary resolved. Operating such can cause server inefficiencies, especially in case To overcome this shortcoming, we propose an adaptive subproblem selection (ASS) strategy to identify most promising further modeling. better leverage...
The ultra-fine grain structure of Al–Zn–Mg–Cu alloy was prepared by equal channel angular pressing (ECAP) and post cold rolling (CR) combined deformation process. effect different on the microstructure, microhardness corrosion behavior ECAP were studied. results show that with increase deformation, dislocation density increased, second phases deformed obviously refined. Grain refinement mainly due to gradual transformation some subgrain boundaries low angle (LAGBs) alloys into high (HAGBs),...
This paper presents a compact-size, low-cost smart antenna with electronically switchable radiation patterns, and reconfigurable polarizations. can be dynamically switched to realize three different polarizations including two orthogonal linear one diagonally polarization. By closely placing several parasitic elements around the driven antenna, beam switching achieved in any of polarization states. In this design, square patch simple feeding network is used as element. The element composed...
A thin radar-infrared stealth-compatible structure with reflectivity below −10 dB in the whole radar X wave band and infrared emissivity less than 0.3 region of 8 μm–14 μm is reported. The designed consists metallic frequency selective surface (MFSS), resistive (RFSS), metal backing from top down, it only 2.1-mm thick. MFSS made up some divided low copper films, RFSS a capacitive array square patches. They are placed close together, working as an admittance sheet because mutual influence...
This communication presents the complete design of a circularly polarized (CP) folded reflectarray (FRA) antenna with an integrated planar structure for first time in open literature. To achieve polarized, printed meander-line polarizer is designed and linearly (LP) FRA. low-profile structure, 2×2 array as feed source instead horn. Thus, whole antenna, including source, LPFRA, polarizer, can be fully fabricated using low-cost circuit board technology. validate concept, right-handed CPFRA...
A main challenge for radar-aided millimeter wave (mmWave) vehicle-to-infrastructure (V2I) communication application, is that it requires mitigating the mutual interference between vehicular radar and operating at same frequency bands. This paper considers joint design of multiple-input multiple-output (MIMO) transmit waveform receive filter bank road side unit (RSU)-mounted in a spectrally crowded V2I environment. With criterion maximizing average signal-to-interference-plus-noise ratio...
Computer simulations have been increasingly used to study physical problems in various fields. To relieve computational budgets, the cheap-to-run metamodels, constructed from finite experiment points design space using of computer experiments (DOE), are employed replace costly simulation models. A key issue related DOE is designing sequential achieve an accurate metamodel with as few possible. This article investigates performance current Bayesian sampling approaches and proposes adaptive...
This article presents a global optimization algorithm via the extension of DIviding RECTangles (DIRECT) scheme to handle problems with computationally expensive simulations efficiently. The new strategy improves regular partition DIRECT flexible irregular in order utilize information from points. metamodelling technique is introduced work speed up convergence, which meaningful for simulation-based problems. Comparative results on eight representative benchmark and an engineering application...
In order to scale standard Gaussian process (GP) regression large-scale datasets, aggregation models employ factorized training and then combine predictions from distributed experts. The state-of-the-art models, however, either provide inconsistent or require time-consuming process. We first prove the inconsistency of typical aggregations using disjoint random data partition, present a consistent yet efficient model for GP. proposed inherits advantages aggregations, e.g., closed-form...
Purpose: We designed a semi-supervised method that effectively utilized few-slice-annotated data for efficient MRI segmentation.
A frequency-reconfigurable antenna for a multiple-input–multiple-output (MIMO) system with electronically steerable radiation patterns in azimuth plane is proposed this letter. For MIMO systems, the are able to reduce correlation between signals and increase channel capacity. There two folded-monopole parasitic array radiator (FM-ESPAR) antennas The pattern of each FM-ESPAR from 0 <formula formulatype="inline" xmlns:mml="http://www.w3.org/1998/Math/MathML"...