Yicong Chen

ORCID: 0000-0003-2827-716X
Publications
Citations
Views
---
Saved
---
About
Contact & Profiles
Research Areas
  • ZnO doping and properties
  • Semiconductor materials and devices
  • Nanowire Synthesis and Applications
  • Advancements in Semiconductor Devices and Circuit Design
  • Graphene research and applications
  • Carbon Nanotubes in Composites
  • Electronic and Structural Properties of Oxides
  • Diamond and Carbon-based Materials Research
  • 2D Materials and Applications
  • Ga2O3 and related materials
  • Advancements in Battery Materials
  • Advanced Battery Materials and Technologies
  • Advanced Thermoelectric Materials and Devices
  • TiO2 Photocatalysis and Solar Cells
  • Wireless Communication Security Techniques
  • Urban Heat Island Mitigation
  • Advanced Photocatalysis Techniques
  • Gas Sensing Nanomaterials and Sensors
  • Plant Virus Research Studies
  • Thermal Radiation and Cooling Technologies
  • Advanced Thermodynamics and Statistical Mechanics
  • Thermal properties of materials
  • Remote Sensing and Land Use
  • Advanced Antenna and Metasurface Technologies
  • Boron and Carbon Nanomaterials Research

Shenzhen University
2020-2025

Xiamen University of Technology
2022-2025

Capital Medical University
2025

Sun Yat-sen University
2015-2024

Chinese Academy of Sciences
2019-2024

Hebei University of Technology
2023-2024

Hong Kong University of Science and Technology
2023-2024

Shanghai Institute of Materia Medica
2024

Ministry of Ecology and Environment
2024

Nanjing Institute of Environmental Sciences
2024

Hard carbon as an anode is critical for the near-future commercialization of Na-ion batteries. However, where Na ions are located at different states charge with respect to local structures hard remains a topic that under debate. Recently, some groups, including ours, have suggested structure–property correlation assigns slope capacity in galvanostatic charge/discharge curves binding structural defects carbon. To test this correlation, herein, we prepared highly defective by microwaving was...

10.1021/acs.chemmater.8b00645 article EN Chemistry of Materials 2018-06-11

A novel oriented nanotube (TN) array on Ti substrate was fabricated by using an electrochemical method. The structure and surface morphology of the TN examined Raman spectroscopy scanning electronic microscopy, respectively. photocatalytic activity arrays evaluated removal methylene blue in aqueous solution. effects its were investigated. It observed that crystal structure, morphologies, sizes greatly influenced anodization voltage calcination temperature. shift absorption edges shorter...

10.1149/1.2203112 article EN Journal of The Electrochemical Society 2006-01-01

Two-dimensional (2D) materials exhibit high sensitivity to structural defects due the nature of interface-type materials, and corresponding can effectively modulate their inherent properties in turn, giving them a wide application range high-performance functional devices. 2D γ-Ga2S3 is defective semiconductor with outstanding optoelectronic properties. However, its controllable preparation has not been implemented yet, which hinders exploring potential applications. In this work, we...

10.1021/acsnano.9b00276 article EN ACS Nano 2019-05-13

ABSTRACT Pulmonary fibrosis is a pathological manifestation that occurs upon lung injury and subsequence aberrant repair with poor prognosis. However, current treatment limited does not distinguish different disease stages. Here, we aimed to study the differential functions of Axl, receptor tyrosine kinase expressing on both macrophages fibroblasts, in whole course pulmonary fibrosis. We used mice Axl total knockout, conditionally knockout or treating inhibitors inflammation stages examine...

10.1111/jcmm.70321 article EN cc-by Journal of Cellular and Molecular Medicine 2025-01-01

K-ion batteries (KIBs) are emerging as an alternative solution for large-scale energy storage. Carbon materials, including graphite and nongraphitic carbons such soft hard carbons, have been studied anode materials However, to date, it has rarely reported that bulk carbon could reach a capacity of 350 mAh/g, given in potential range 0–2 V. Herein, we report (SC) obtained by annealing organic molecular solid PTCDA at low temperature 700°C demonstrates reversible excellent rate capability,...

10.1021/acsaem.9b00125 article EN ACS Applied Energy Materials 2019-05-23

Being a typical graphene-like two-dimensional (2D) material, borophene has received lot of attention due to its low density, high electron mobility, large Young's modulus, and good chemical stability. Compared with the corresponding bulk counterparts, 2D larger specific surface area, higher conductivity, smaller work function, finding potential applications in high-speed transistors, optoelectronic detection, field emission (FE), mechanical enforcement areas. In this paper, tetragonal sheets...

10.1021/acs.cgd.3c00265 article EN Crystal Growth & Design 2023-05-16

High-performance thermoelectric (TE) materials with great flexibility and stability are urgently needed to efficiently convert heat energy into electrical power. Recently, intrinsically crystalline, mechanically stable, flexible inorganic TE fibers that show properties comparable their bulk counterparts have been of interest researchers. Despite remarkable progress in moving toward room-temperature conversion, the figure-of-merit value (ZT) bending still need enhancement. Herein,...

10.1002/adma.202202942 article EN Advanced Materials 2022-07-11

Large-area zinc oxide (ZnO) nanowire arrays have important applications in flat-panel X-ray sources and detectors. Doping is an effective way to enhance the emission current by changing conductivity lattice structure. In this paper, large-area indium-doped ZnO were prepared on indium-tin-oxide-coated glass substrates thermal oxidation method. with indium concentrations up 1 at% was achieved directly oxidizing In-Zn alloy thin film. The growth process subsequently explained using a...

10.3390/nano11010240 article EN cc-by Nanomaterials 2021-01-18

Abstract Metal-insulator-semiconductor (MIS) heterostructures have important applications in vacuum microelectronic devices. Among these, graphene-insulator-semiconductor (GIS) heterostructure field electron emitters are among the most widely utilized. Improving emission performance is a major challenge for GIS emitters. A comprehensive theoretical model needed to predict process from such structure. In this work, calculation was carried out on current an structure based tunneling that...

10.1088/1402-4896/adae65 article EN Physica Scripta 2025-01-24

The preparation of high-performance hard coatings on the surface cemented carbide PCB (printed circuit board) microdrills can effectively decrease rapid tool wear that occurs during cutting. In this study, arc ion plating technology was employed to deposit conventional AlTiN columnar crystal single-layer and nanocrystalline substrates microdrills. Additionally, a novel composite coating with alternating layers designed deposited. mechanical properties morphological characteristics three...

10.3390/coatings15050520 article EN Coatings 2025-04-26

Abstract Endogenous retroviruses (ERVs) represent host genomic ‘fossils’ of ancient viruses. Foamy viruses, including those that form endogenous copies, provide strong evidence for virus-host co-divergence across the vertebrate phylogeny. foamy viruses (EFVs) have previously been discovered in mammals, amphibians, and fish. Here we report a novel virus, termed ERV-Spuma-Spu, genome tuatara (Sphenodon punctatus), an endangered reptile species endemic to New Zealand. Phylogenetic analyses...

10.1093/ve/vez001 article EN cc-by-nc Virus Evolution 2019-01-01

X-ray sources have important applications in medical diagnosis, industrial inspection, etc. Transparent source has not been reported before, which enables the such as simultaneous imaging using and visible light. In this article, a fully vacuum-encapsulated transparent flat-panel was prepared by ZnO nanowires cold cathode indium-tin-oxide (ITO) transmission anode. The effect of thicknesses ITO film on radiation intensity studied. A dose rate 6.85 mGy/s measured at 5 cm front (FPXS) under...

10.1109/ted.2023.3267757 article EN IEEE Transactions on Electron Devices 2023-05-01
Coming Soon ...