A5065924628- Catalysis for Biomass Conversion
- Catalysis and Hydrodesulfurization Studies
- Catalysts for Methane Reforming
- Catalytic Processes in Materials Science
- Mesoporous Materials and Catalysis
- Nuclear reactor physics and engineering
- Nuclear Engineering Thermal-Hydraulics
- X-ray Diffraction in Crystallography
- Asymmetric Hydrogenation and Catalysis
- Layered Double Hydroxides Synthesis and Applications
- Zeolite Catalysis and Synthesis
- Electrocatalysts for Energy Conversion
- Chemical Thermodynamics and Molecular Structure
- Public Health in Brazil
- Healthcare and Environmental Waste Management
- Chemical and Physical Properties in Aqueous Solutions
- Catalysis and Oxidation Reactions
- Cyclone Separators and Fluid Dynamics
- Graphite, nuclear technology, radiation studies
- Crystallization and Solubility Studies
- Nuclear and radioactivity studies
- Advanced Photocatalysis Techniques
- Supercapacitor Materials and Fabrication
- Risk and Safety Analysis
- TiO2 Photocatalysis and Solar Cells
Universidade Estadual de Campinas (UNICAMP)
2006-2020
Centro Universitário da Cidade
2005-2008
Hospital de Clínicas da Unicamp
1998
The Catalytic Wet Air Oxidation (CWAO) of phenol using copper oxide catalysts supported by γ-Al2O3, TiO2, and pillared clay was evaluated to identify which these the most appropriate for this reaction. CuO/PILC, CuO/γ-Al2O3 CuO/TiO2 were successful at removing resulted in more than 96% conversion. Among catalysts, produced largest amount CO2, lowest intermediate products leaching. These results showed that CuO/γ-Al2O3catalyst best end However, methods used study did not allow us reaction...
This work aimed to establish the relationship between compositions and pH of ATPS PEG 6000/CaCl2 proteins partition from maize malt also simplify process optimization in for a statistical model, established by response surface methodology (RSM). Results showed that these were no influence on phase diagrams composition tie line length ATPS. SRM analyses elevated larger best conditions recovering proteins. The maximum coefficient was about 4.2 achieved single purification step. theoretical...
Even with rigorous environmental regulations, phenol still is a major contaminant. One possible solution the use of heterogeneous photocatalysis due to low chemical addition, feasibility and reliability be implanted on cost-effective industrial process. TiO2 most employed photocatalyst because its favorable (photo) properties ZnO considered one best alternative for that. Other oxides were tested in lesser proportions, like CuO Ga2O3. When dispersed as slurry, higher degradation rates are...