A5101590050- Welding Techniques and Residual Stresses
- Optical measurement and interference techniques
- Laser and Thermal Forming Techniques
- 3D Surveying and Cultural Heritage
- Surface Roughness and Optical Measurements
- Industrial Vision Systems and Defect Detection
- Advanced Technologies in Various Fields
- Applied Advanced Technologies
- Distributed Control Multi-Agent Systems
- Advanced Measurement and Detection Methods
- Thermography and Photoacoustic Techniques
- Robotic Path Planning Algorithms
- UAV Applications and Optimization
- AI and Big Data Applications
- Gear and Bearing Dynamics Analysis
- Advanced Measurement and Metrology Techniques
- Fault Detection and Control Systems
- Advanced ceramic materials synthesis
- Machine Fault Diagnosis Techniques
- Advanced materials and composites
- Advanced Welding Techniques Analysis
- Optical Systems and Laser Technology
- Fiber-reinforced polymer composites
Anhui Jiyuan Software
2022-2023
University of Science and Technology of China
2021
Heilongjiang Institute of Technology
2020
Auburn University
2003-2004
Tianjin University
2001-2002
A study was conducted to investigate the feasibility of using a point infrared sensor monitor and control penetration during Submerged Arc welding (SAW) process. The SAW process, small tractor units, is extensively used in ship building industry because high deposition rates that may be achieved. Typical problems encountered by these units include seam gap variations, plate offset, changes thickness, tracking misalignment, inclinations heat sinks such as stiffeners, chill blocks temporary...
The recursive filtering algorithm, a simpler method of for electronic speckle pattern interferometry (ESPI) images, is presented and studied in the paper. In pace with new method, applied software developed specially. By experimental demonstration, it shows that technique most effective speedy ESPI fringe patterns so far. Comparing images before after filtering, we can see these advantages novel clearly.
In order to solve the problem of poor effect and long time-consuming current intelligent management building construction, an method whole process construction based on BIM Technology is proposed. Lean mode, construct three-dimensional virtual model project, optimize process, improve process. Finally, experiment proves that in has a good practical application which can effectively long-time fully meet research requirements.
In the swarm formation control system by leader-follower strategy, obstacle avoidance is key requirement of unmanned aerial vehicle (UAV) to coordinate trajectory planning, while traditional artificial potential field (APF) ignores problem that UAV needs return scheduled route immediately after avoidance. Based on rules, this paper proposes a planning scheme based improved (IAPF). Though IAPF, considers minimum turning radius factor when avoiding obstacles, does not deviate from avoidance,...
On the backdrop of energy conservation and emission reduction, fault diagnosis is an important way to promote reduction. Traditional bearing methods usually show a series difficulties including difficulty in feature extraction, low robustness multiple pre-processing steps. In allision issues above, rolling technique proposed this paper taking CNN EMD-LSTM as foundation, which can automatically identify process information. The original vibration signals were reconstructed by EMD denoising...
For finding the defect inside of rails, we usually use ultrasound to inspect rails and obtain point clouds data returned ultrasonic signals after preprocessing. The quantity points in each cloud is not fixed, are disordered unstructured. have heterogeneous attributes which include only continuous coordinates but discrete frequencies ultrasound. classifying special clouds, propose a network architecture, named Multi-Branch Global Graph Convolution Network. better utilizing features point,...