A5046082600- X-ray Diffraction in Crystallography
- Electrodeposition and Electroless Coatings
- Remote Sensing and LiDAR Applications
- Magnetic Properties and Synthesis of Ferrites
- IoT-based Smart Home Systems
- Smart Grid Energy Management
- Semiconductor materials and devices
- Forest Ecology and Biodiversity Studies
- Forest ecology and management
- Metal and Thin Film Mechanics
- Pigment Synthesis and Properties
- Semiconductor materials and interfaces
- Corrosion Behavior and Inhibition
- Iron oxide chemistry and applications
- Silicon Carbide Semiconductor Technologies
- RNA and protein synthesis mechanisms
- Landslides and related hazards
- Crystallography and Radiation Phenomena
- Advanced ceramic materials synthesis
- Advanced X-ray Imaging Techniques
- Remote Sensing in Agriculture
- Flood Risk Assessment and Management
- Additive Manufacturing and 3D Printing Technologies
- Metallurgical and Alloy Processes
- Synthetic Aperture Radar (SAR) Applications and Techniques
Keio University
2024
Okinawa Institute of Science and Technology Graduate University
2022
The University of Tokyo
2005-2021
Ryukoku University
2012-2015
Hiroshima Institute of Technology
2010-2013
Kanazawa University
2012
Nara Institute of Science and Technology
2007-2010
Bridgestone (Japan)
2007
Utsunomiya University
2005
Forestry and Forest Products Research Institute
2000-2004
In order to elucidate the three‐dimensional genetic structure of Quercus crispula in mountainous regions, level and distribution variation were evaluated within among 19 populations at altitudes ranging from 850 1750 m around Chichibu Mountains, central Japan, using seven microsatellite markers. Compared with intermediate (1000–1500 m), both expected heterozygosity allelic richness significantly weaker for lower (≤1000 m) not but slightly higher (≥1500 altitudes. These results suggest that...
Click to increase image sizeClick decrease size Acknowledgments This research was supported by the following grants: Knowledge Innovation Key Project (KZCX-SW-317/CX10G-E01-08), Chinese Academy of Sciences and director's grant Institute Geographical & Natural Resources Research, Sciences. It also financially ACT-JST: Research Development for Applying Advanced Computational Science Technology Japan Corporation.
Reconstitution of the DNA amplification system in microcompartments is primary step toward artificial cell construction through a bottom-up approach. However, >100 kbp micrometer-sized reactors has not yet been achieved. Here, implementing fully reconstituted replisome Escherichia coli water-in-oil droplets, we developed in-droplet replication cycle reaction (RCR) system. For 16 template DNA, RCR yielded positive signals with high success rate (82%) for from single molecule DNA. The 208 was...
秩父山地の山地帯天然林に配置した計6.875haの大面積プロットにおける胸高直径5cm以上(7,940本)の毎木データから,樹種個体群の空間分布特性およびその地形依存性について明らかにした。大面積プロットは樹種構成により四つの植生型に区分され,55の構成樹種は植生型ごとの胸高断面積合計から四つの種群に分けられた。それぞれの樹種の空間分布特性はCCA解析によると地形傾度に対応していた。一方,本調査区の主要樹種であるツガ,ブナ,イヌブナなどは安定した個体群維持を行っており,これら3種を主体とする各植生型は,長期間にわたり大きな撹乱がなかったこと,表層土の侵食と堆積が全域で起こっていること,乾湿傾度が地形条件によって変化していること等によって配列されたものであることが示唆された。さらにこれらの植生パターンの変化幅は標高に伴う地形傾度の程度により規定されていると考えられた。
The electroless plating composite film Ni-P-Al2O3 was prepared on a mild steel of SS400 with stirring the solution. became thinner and rougher when Al2O3 particles were blended into corrosion resistance wear largely enhanced in comparision to Ni-P film.
The van der Waals compound CeTe2Se shows that the magnetic moments in ordered state point along hard axis, whereas they easy axis CeTe3. In order to investigate properties of CeTe3 and CeTe2Se, we performed inelastic neutron scattering experiments, crystalline electric field (CEF) excitations were observed. From CEF analysis, determined parameters revealed ground states are same \(\Gamma_{7}^{(1)}\) consistent with easy-plane-type anisotropy. A comparison other compounds which suggests...
Abstract. Waveform LiDAR systems is widely used in several fields such as terrain survey, disaster monitoring and forest monitoring. Especially, research, using an echo signal expected for understanding structural characteristics of the forest. However, highly depends on sensor configuration, footprint size, canopy structure, condition. Therefore, it not easy to understand attributes from signal. In this paper, we describe development application model which simulate laser intersections...
Abstract Three types of TO-247 package SiC-MOSFETs, denoted as A, B and C fabricated by different manufacturers, were subjected to thermal cycle tests (TCT) ranging from −40°C 200°C a high temperature storage test (HTST) at in air. Their reliability was continuously investigated based on electrical characterizations, X-ray inspection scanning acoustic tomography (SAT). Intermittent SAT observation revealed that, regardless the device type, epoxy resin (encapsulant) first peeled Cu die pad...
In this paper, a method of operating household electric appliances using remote controller that incorporates browser as platform is proposed. A prototype was prepared in order to evaluate the effectiveness proposed method.
This paper proposes a management method of personal health conditions by the automatic control household electrical appliance, using human physical information and collected from appliance sensors database. Experiments were conducted creating an experimental system. As result, it has been proven possible to store in database also for appliances be automatically controlled self-estimation user's operations, based on sensor data.