A5111373830- Conducting polymers and applications
- Perovskite Materials and Applications
- Thin-Film Transistor Technologies
- Silicon and Solar Cell Technologies
- Dental Trauma and Treatments
- Oral and gingival health research
- Dental Erosion and Treatment
- Respiratory Support and Mechanisms
- Spacecraft Design and Technology
- Advanced materials and composites
- Mesoporous Materials and Catalysis
- Impact of Light on Environment and Health
- Organic Light-Emitting Diodes Research
- Analytical Chemistry and Sensors
- Semiconductor materials and interfaces
- Advanced Sensor and Energy Harvesting Materials
- Injection Molding Process and Properties
- Fluoride Effects and Removal
- Space exploration and regulation
- Electrowetting and Microfluidic Technologies
- Organic Electronics and Photovoltaics
- Cardiac Arrest and Resuscitation
- Chalcogenide Semiconductor Thin Films
- Oral microbiology and periodontitis research
- Advanced ceramic materials synthesis
National Taiwan University
1980-2025
Far Eastern Memorial Hospital
2025
The introduction of additives with specific functional groups is an important approach to extend the operational lifetime perovskite solar cells (PSCs). Herein, effect benzoic acid (0F‐B), 4‐fluorobenzoic (1F‐B), and 2,3,4,5,6‐pentafluorobenzoic (5F‐B) on performance stability MAPbI3‐based PSCs systematically investigated. These can both chelate onto lead ions form hydrogen bond methyl ammonium ions. combined interactions result in increased activation energy for nucleation crystals,...
Abstract Root surface demineralization is widely used as an adjunct to periodontal treatment. To clarify the influence of citric acid root conditioning on wound healing, effects and associated extracellular acidosis viability (MTT assay), attachment protein synthesis ([ 3 H]‐proline incorporation into tirchloroacetic acid‐precipitated proteins) human gingival fibroblasts (GF) were investigated. A concentration 47.6 mmol/L (pH 2.3) in water led total cell death within three minutes...
The control of impurity is crucial to the ingot quality and yield in directional solidification multi-crystalline silicon for solar cells. major impurities, such as metals, are mainly from quartz crucible nitride coating. use high-purity materials mitigates problem, but it also increases cost. Another way diffusion barriers between these reduce incorporation impurities. In this study, polysilazane barium oxide coatings with different layer configurations were considered. With barrier layer,...
It is generally accepted that MgO additions enhance the sintering of alumina. The distribution low concentration required is, however, difficult to attain and critical final properties microstructures. To improve distributions in ceramic injection‐molded (CIM) alumina, Mg‐containing precursors, Mg‐stearate Mg‐acetate, were added during kneading step CIM process, results compared with those from adding particles. Of three additives, showed highest sintered density bending strength. This was...
Powdered human enamel treated for three minutes each with a CaHPO 4 ·2H 2 O forming solution and fluoride solution, then suspended in "synthetic saliva" 72 hours acquired large amount of apatitic fluoride. This appears to form after the treatment.