A5019541324- Electromagnetic Scattering and Analysis
- Antenna Design and Analysis
- Advanced Antenna and Metasurface Technologies
- Electromagnetic Simulation and Numerical Methods
- Microwave Engineering and Waveguides
- Electromagnetic Compatibility and Noise Suppression
- Numerical methods in engineering
- Antenna Design and Optimization
- Silicon Carbide Semiconductor Technologies
- Energy Harvesting in Wireless Networks
- Energy Efficient Wireless Sensor Networks
- Electronic Packaging and Soldering Technologies
- Metamaterials and Metasurfaces Applications
- Electromagnetic Compatibility and Measurements
- 3D IC and TSV technologies
- Advanced Battery Technologies Research
- Multilevel Inverters and Converters
- HVDC Systems and Fault Protection
- Advanced X-ray Imaging Techniques
- Semiconductor Quantum Structures and Devices
- Electromagnetic wave absorption materials
- Phytochemical compounds biological activities
- Advancements in Battery Materials
- Radio Frequency Integrated Circuit Design
- X-ray Diffraction in Crystallography
Tianjin University of Traditional Chinese Medicine
2025
Southwest University of Science and Technology
2012-2024
Brookhaven National Laboratory
2003-2011
Johannes Kepler University of Linz
2001
Abstract As an indispensable aspect of the battery management system, accurate lithium state charge (SOC) estimation has attracted wide attention. This study proposes innovative adaptive genetic algorithm online intermittent parameter identification method to improve model accuracy based on second-order RC equivalent circuit as model. Addressing limitations offline and fixed crossover mutation probabilities in traditional enhances algorithm's efficiency, thereby overcoming constraints...
The use of in situ analytical electron microscopy for probing nanoscale electrochemistry enables us to understand dynamic changes the chemistry and structure bulk materials interfaces over course electrochemical processes. Analytical transmission (TEM) has been used extensively study electrode ex past. This article describes a novel instrumental system that combines with advanced spectroscopy probe phenomena an all solid-state battery. intricacies experimental set-up are discussed, in-situ...
Silicon carbide (SiC) devices can significantly increase power efficiency, temperature reliability, capacity, and density because of their outstanding characteristics. Nevertheless, in the bridge-leg configuration a converter, high-speed switching capability SiC mosfets is often restricted by coupling noise between high-side mosfet low-side mosfet. The caused high ${dv/dt}$ ${di/dt}$ transient will loss risk breakdown. In order to completely take advantage superior feature mosfets, novel...
The wireless power transfer (WPT) method for electric vehicles (EVs) is becoming more popular, and to ensure the interoperability of WPT systems, Society Automotive Engineers (SAE) established J2954 recommended practice (RP). It includes powering frequency, electrical parameters, specifications, testing procedures, other contents EV WPT. Specifically, it describes ranges self-inductances transmitting coil, receiving coupling coefficient (k), as well impedance matching values system....
The structure of self-organized quantum wires buried at the interfaces a SiGe/Si multilayer is investigated by grazing incidence small-angle x-ray scattering. A nearly periodic distribution wires, well described short-range ordering model, gives rise to intensity satellite maxima in reciprocal space. shape wire cross section determined from heights these maxima, and analysis reveals that conventional step-bunching model not sufficient explain shape.
This paper studies the electromagnetic properties of defected ground structure (DGS) with von Koch snowflake fractals. First, fractal is employed in dumbbell shaped DGS, and we have discovered that it has characteristics a low-pass filter out-of-band rejection increases iterations. In consideration fabrication accuracy performance, third iteration been adopted. Based on this structure, designed narrow-band wide-band to verify our theory. From simulated measured results, can see level greatly...
Far-end crosstalk (FEXT) can be a problem in the design of printed circuit boards (PCB) for incoming fifth generation double data rate (DDR5). In this paper, FEXT mitigation method is proposed. This adds an additional layer homogeneous dielectric substrate with or without metal to make transmission line more homogeneous. Therefore, capacitive cancel out inductive at far end. our research, lines tabbed routing are analyzed and simulated. Finally, frequency-domain time-domain simulated results...
Abstract A simple wideband planar antenna with a separated fence structure is presented in this study for 4/5G base station application. To improve the front‐to‐back ratio (FBR) and half‐power beamwidth (HPBW) of proposed antenna, five parasitic structures are designed. This design can effectively suppress surface wave propagating along metal ground increase radiation performance low elevation area. After integrating fence, FBR improved by 6 dB on average. And HPBW increased average above 3...
In this article, a nonconformal and nonoverlapping domain decomposition method (DDM) based on surface integral equation (SIE) is proposed for the electromagnetic (EM) scattering or radiation of multiscale metallic targets. To reduce unknown amount conventional SIE EM simulation, we apply curved triangular elements higher order hierarchical vector (HOHV) basis functions to SIE. Next, increase flexibility geometrical modeling accelerate convergence presented system electrically large targets,...
In this paper, a notch-band bandpass filter based on the composite right/left-handed transmission line (CRLH TL) loaded with quarter-wavelength resonator (QWR) is proposed. By substituting metallic via hole of conventional CRLH TL QWR, notch passband frequency response an adjustable band in middle has been achieved. Also, order to increase out-of-band rejection, pair open-ended stub resonators added at input and output feed lines. The fabricated measured, measurement results are good...
Crosstalk becomes a serious problem in microstrip design of printed circuit boards (PCBs) DDR5. In high-density and high-speed PCBs, widening space or putting shielding between traces to mitigate crosstalk noise may become less effective, because the limited space. This paper presents simple efficient reduction approach by using coverlay coated lines. is available variety film adhesive thicknesses, which commonly used materials for resistance welding transform PCB production. Based on...
In this paper, we use the surface integral equation (SIE) based on MLFMA method to study electromagnetic scattering characteristics of moving unmanned air vehicle (UAV) over a randomly rough surface. work, 2D finite impulse response (FIR) filter theory and fast Fourier transform (FFT) are adopted generate three dimensional (3D) Gaussian surfaces. Moreover, tremor model is utilized effect by flow during flight, when UAV analyzed. Then, for two different flight paths, dynamic radar cross...