A5061005401- Electromagnetic Compatibility and Noise Suppression
- Antenna Design and Analysis
- Microwave Engineering and Waveguides
- Advanced Antenna and Metasurface Technologies
- Radioactive element chemistry and processing
- Antenna Design and Optimization
- Advanced Photocatalysis Techniques
- Electromagnetic Compatibility and Measurements
- Electromagnetic Scattering and Analysis
- Electromagnetic Simulation and Numerical Methods
- Nuclear Materials and Properties
- 3D IC and TSV technologies
- Electronic Packaging and Soldering Technologies
- Nuclear materials and radiation effects
- Plasmonic and Surface Plasmon Research
- Semiconductor materials and devices
- Full-Duplex Wireless Communications
- Radio Frequency Integrated Circuit Design
- Energy Harvesting in Wireless Networks
- Electrostatic Discharge in Electronics
- Soil Moisture and Remote Sensing
- Chemical Synthesis and Characterization
- Cryptographic Implementations and Security
- Microbial Fuel Cells and Bioremediation
- Direction-of-Arrival Estimation Techniques
Southwest University of Science and Technology
2022-2024
Yangzhou University
2024
Jilin Agricultural University
2024
Abstract Reduction of soluble hexavalent uranium (U(VI)) to sparingly tetravalent (U(IV)) with semiconductor photocatalysts is recognized as a novel, green, and simple U‐extraction method. Furthermore, effective charge separation utilization are critical factors achieve high‐efficiency U(VI) photoreduction. Herein, UiO‐66‐based heterostructured photocatalyst (MnO x /UiO‐66/Ti 3 C 2 T ) spatially separated dual cocatalysts nanoparticles Ti MXene nanosheets) successfully developed for...
Reduction of hexavalent uranium [U(VI)] by the photocatalytic method opens up a novel way to promote selectivity, kinetics, and capacity during removal, where organic molecules act as sacrificial agents. However, addition agents can cause secondary environmental pollution increase cost. Here, UiO-66-based photocatalyst (denoted MnOx/NH2-UiO-66) simultaneously with efficient U(VI) confinement sites water oxidation was successfully developed, achieving excellent removal without In...
Doping is a simple method to modulate the electronic configuration of semiconductor photocatalysts. This study regulated energy band structure CdSe nanosheets by Ag doping, which reduced bandwidth increasing carrier density, thereby improving efficiency photocatalytic reduction uranium nanosheets. A 96% removal U(VI) was achieved 3% Ag-CdSe nanosheets, 1.9 and 1.2 times higher than that pristine (50%), 1% (81%), respectively. Additionally, at pH = 4.0 solid–liquid ratio 0.25, (765 mg/g) 2.2...
Glide symmetry transmission line (TL) is a highly symmetric TL with characteristics such as reduced frequency dispersion and merged passband. The field distribution of single-layer double-layer spoof surface plasmon polaritons (SSPPs) unit glide are studied in this paper. It found that the double layer structure stronger slow wave effect more suitable for scanning radiation higher rates. Thus, T-shaped proposed. Such exhibits confinement degrees freedom modulating characteristics. Besides...
In this study, a leading–drawing–cutting–type profiled root–trimming device was designed to address the problems of high impurity and damage rates that occur with operation pull–cut garlic harvester. The main components include pull–clamp mechanism, roll–pulling knife lifter, gearbox, universal drive shaft, motor, frame that, together, can complete for An orthogonal regression test carried out by taking roller diameter, inclination angle, rotation speed, working speed as factors rate...
The proteins encoded by Influenza A virus (IAV) evade the innate immune system through diverse strategies to facilitate their replication. However, regulatory mechanisms remain not fully understood. In this study, we identified that H9N2 PB1 protein suppressed activities of IFN-β, ISRE, and NF-κB promoters. Furthermore, inhibited phosphorylation IRF3, IκBα, TBK1 secretion IFN-β. results demonstrated as a negative regulator RIG-I signaling pathway. Subsequent investigations revealed specific...
In this paper, a novel algorithm with rotating coordinate system is proposed to improve the total harmonic distortion (THD) of PWM rectifiers. Aiming at solving disadvantages poor dynamic response, unstable switching frequency, and large calculation burden in some current control methods, method employs active reactive separately while modifying error. The verified through single-phase rectifier. Based on measured results compared many other algorithms, such as peak mode (PCMC), average...
This paper proposes a 2x-thru standard deembedding method for surface components in high-speed PCBs. uses one single symmetric fixture to de-embed device under tests (DUT) by extracting from the model time domain channel characteristic analysis (TCC). The feasibility and accuracy of are verified using data obtained simulated models with HFSS, de-embedding process is achieved Matlab. proposed compared conventional Thru-reflect-line (TRL) method, high precision has been proved. It requires far...
This paper presents the design of a high-frequency test fixture for high-speed connectors. Specifically, after analyzing and designing board material, laminate structure, trace signal via impedance consistency bandwidth interconnect structure are verified through TDR S-parameter simulations conducted in HFSS. PCB layout is generated using Cadence. The results confirm that differential meets requirements connector testing. Within frequency range 0-30 GHz, difference between S11 S21 2x-thru...