A5100718734- Surface Modification and Superhydrophobicity
- High-Temperature Coating Behaviors
- Advanced Sensor and Energy Harvesting Materials
- Metallurgical Processes and Thermodynamics
- Membrane Separation Technologies
- Advanced materials and composites
- Microstructure and Mechanical Properties of Steels
- High Temperature Alloys and Creep
- Recycling and Waste Management Techniques
- Metal and Thin Film Mechanics
- Fatigue and fracture mechanics
- Advanced Materials and Mechanics
- Pickering emulsions and particle stabilization
- Crystallization and Solubility Studies
- Extraction and Separation Processes
- Minerals Flotation and Separation Techniques
- Metal Alloys Wear and Properties
- Iron and Steelmaking Processes
- X-ray Diffraction in Crystallography
- Enhanced Oil Recovery Techniques
- Thermal properties of materials
- Synthesis and biological activity
- Magnetic properties of thin films
- Metal Extraction and Bioleaching
- Heavy metals in environment
Nanjing University of Aeronautics and Astronautics
2021-2025
First Affiliated Hospital of Henan University of Science and Technology
2025
Third Affiliated Hospital of Sun Yat-sen University
2025
Sun Yat-sen University
2025
Ministry of Agriculture and Rural Affairs
2025
Inner Mongolia Agricultural University
2025
Changzhou University
2025
Huanghuai University
2025
Southwest Jiaotong University
2007-2024
China University of Petroleum, East China
2010-2024
Abstract Oil–water separation membranes easily fail to oil foulants with low surface energy and high viscosity, which severely limits these membranes’ applications in treating oily wastewater. Herein, an oil–water membrane by bioinspired bubble‐mediated antifouling strategy is fabricated via growing hierarchical cobalt phosphide arrays on stainless steel mesh. The as‐prepared superhydrophilic/superaerophobic electrocatalytic for hydrogen evolution under water, helps rapidly generate release...
MOF/COF-based hybrids show the properties of precisely tunable compositions and structures, provide a broad range potential applications in gas sorption separation, catalysis, energy transfer, biomedicine, etc.
Abstract Photodetectors (PDs) based on perovskite nanowires are among the most promising next‐generation photodetection technologies; however, their poor long‐term stability is biggest challenge limiting commercial application. Herein, an ionic liquid, 1‐butyl‐3‐methylimidazolium tetrafluoroborate (BMIMBF 4 ), incorporated as additive into methylammonium lead triiodide (MAPbI 3 ) nanowires; this not only effectively passivates defects to inhibit degradation but also leads formation of...
Abstract The tunable wettability by pH‐stimulus has great potential in liquid adhesion, transport, collection, and separation due to its rapid response wide control range. However, achieving pH‐regulated on the selected region of material without acid–base contamination presents a distinct challenge for existing methods. Here, scalable conductive network membrane is prepared with switchable regulating interfacial pH. generation diffusion pH are regulated through confinement electrolysis...
The relationship between body roundness index (BRI), a new obesity index, and frailty has not been established. This study aims to compare the associations of traditional mass (BMI) BRI with risk all-cause mortality. clinical data 15,157 participants over 40 years old from National Health Nutrition Examination Survey (NHANES) 2003 2018 were analyzed. Based on weighted logistic regression, COX regression restricted cubic spline, BMI odds mortality estimated. receiver operating characteristic...
Significance Driving liquid microdroplets has been challenging due to the large contact angle hysteresis and insufficient driving force at microscale. We designed a strategy directionally transport water oil microdroplets. By simply mounting hydrogel dots on slippery surface arrest lubricant menisci, spontaneously formed capillary pumps continuously high efficiency. Such is universally applicable droplets of different tensions sizes, yet with little substrate preparation effort. Furthermore,...
Biochar (BC) derived from waste products is a cost-effective sorbent for remediation of metal-contaminated soils. We studied the kinetics and adsorption mechanisms removal metal ions, such as lead (Pb2+) cadmium (Cd2+) with biochar. The capacities BC Pb2+ Cd2+ increased after alkaline treatment. highest sorption were 175.53 68.08 mg g–1, Pb Cd, respectively. Langmuir isotherm pseudo second kinetic equation could well fit processes, revealing that by are complex predominantly controlled...
A multivariate linear regression model was proposed to achieve short period prediction of PM2.5 (fine particles with an aerodynamic diameter 2.5 μm or less). The main parameters for the included data on aerosol optical depth (AOD) obtained through remote sensing, meteorological factors from ground monitoring (wind velocity, temperature, and relative humidity), other gaseous pollutants (SO2, NO2, CO, O3). Beijing City selected as a typical region case study. Data aforementioned variables city...
Abstract Flexible actuation of droplets is crucial for biomedical and industrial applications. Hence, various approaches using optical, electrical, magnetic forces have been exploited to actuate droplets. For broad applicability, an ideal approach should be programmable able arbitrary size composition. Here we present “additive-free” method programmably manipulate water, organic, biological fluids composition, as well solid samples, on a ferrofluid-infused porous surface. We specifically...
The carrier transport layer with reflection reduction morphology has attracted extensive attention for improving the utilization of light. Herein, we introduced single-layer hollow ZnO hemisphere arrays (ZHAs) behaving light trapping effect as electron in perovskite photodetectors (PDs). ZHAs can not only reduce reflection, but also widen angle effective incident and especially transfer distribution optical field from ZnO/FTO interface to active confirmed by 3D finite-difference time-domain...
The barrier layer between thermoelectric (TE) legs and electrodes has crucial impact on the electrothermal conversion efficiency of TE device; however, interfacial reaction Ni metal with in traditional Bi2Te3-based devices is harmful to device performance. Herein, a high-quality Ni-based alloy been fabricated both n-type p-type by electroplating method. situ XRD results indicate that as-prepared remain stable even at 300 °C. high-resolution high-angle annular dark field scanning transmission...
The betaine-type amphoteric surfactant exhibits excellent ability in reducing oil–water interfacial tension for many kinds of crude oil, but less attention is paid to its adsorption behavior on oil reservoir rock. In this paper, a high-performance liquid chromatography (HPLC) method established measure the betaine quartz sand. mobile phase consists methanol and water (methanol/water = 90:10 or 85:15 by volume). column temperature 40 °C; flow rate 1 mL/min; sample volume 20 mL. On basis...