A5108918404- Advanced materials and composites
- Advanced ceramic materials synthesis
- Additive Manufacturing Materials and Processes
- High Entropy Alloys Studies
- Rock Mechanics and Modeling
- Corporate Finance and Governance
- Spectroscopy and Chemometric Analyses
- Soft Robotics and Applications
- Drilling and Well Engineering
- Micro and Nano Robotics
- Diamond and Carbon-based Materials Research
- Geotechnical Engineering and Analysis
- Oil Spill Detection and Mitigation
- Additive Manufacturing and 3D Printing Technologies
- Landslides and related hazards
- Nonlinear Optical Materials Studies
- Microbial Community Ecology and Physiology
- MXene and MAX Phase Materials
- Molecular Communication and Nanonetworks
- Fusion materials and technologies
- Electric Motor Design and Analysis
- Boron and Carbon Nanomaterials Research
- Advanced Sensor and Energy Harvesting Materials
- Biomedical and Engineering Education
- Electric Power System Optimization
Fudan University
2023-2025
Tsinghua University
2018-2024
Northwestern Polytechnical University
2024
Northeast Agricultural University
2019-2024
Shanghai Jiao Tong University
2023-2024
Shandong University of Science and Technology
2019-2023
Tianjin Normal University
2023
Zhengzhou University of Light Industry
2019-2023
North Minzu University
2022-2023
Harbin Institute of Technology
2023
HfC-SiC modified C/C composites containing in situ formed Si-HfC-HfSi2 ablation resistant layer and SiC oxidation were successfully prepared by reactive melt infiltration (RMI) combined with gaseous silicon (GSI). A comparative study was conducted on the anti-oxidation anti-ablation performance of C/C-HfC-SiC GSI (noted as RG-CHS) without R-CHS). After at 1500 °C for 200 min, oxide film RG-CHS remained intact. The mass linear rates decreased from 1.31 mg/s 7.36 μm/s to 0.12 −0.22 after...
Abstract This paper mainly reviews the field-effect transistor technology most involved in modern electronics industry. Short channel effect promotes continuous update of field structure. Therefore, principle and influence short is first introduced. focuses on development history current status fin structure gate-all-around transistors, as well their respective technical difficulties. By reviewing these two main technologies, process difficulties are basically clarified. At same time,...
The laser powder bed fusion manufactured Ti-6Al-4 V alloy predominantly consists of α' martensite, resulting in excellent strength but limited ductility, hinders widespread application. Therefore, it is crucial to achieve the decomposition martensite and improve ductility. However, reverse transformation behavior its mechanism β phase, as well stability remain unclear. Our findings demonstrate that phase follows a diffusion-controlled process. into α + initiates at approximately 550 ℃, while...
The asperity wear of rock joints significantly affects their shear behaviour. This study discusses the damage asperities on joint surface, highlighting roughness degradation characteristics during process. direct experiment artificial specimens containing was conducted under different normal stresses based three-dimensional scanning technology. These experimental results showed contribution to degeneration, such as height, zone, and volume degeneration. coefficient obtained in laboratory...