A5101761814- Thallium and Germanium Studies
- Radioactive element chemistry and processing
- Diamond and Carbon-based Materials Research
- Analytical chemistry methods development
- Chemical Synthesis and Characterization
- Inorganic Chemistry and Materials
- Orthopaedic implants and arthroplasty
- Extraction and Separation Processes
- MXene and MAX Phase Materials
- Fiber-reinforced polymer composites
- Mechanical Behavior of Composites
- Layered Double Hydroxides Synthesis and Applications
- Anomaly Detection Techniques and Applications
- Adversarial Robustness in Machine Learning
- Explainable Artificial Intelligence (XAI)
- Phosphorus and nutrient management
- AI and Multimedia in Education
- Effects and risks of endocrine disrupting chemicals
- Plant and Biological Electrophysiology Studies
- Advanced Sensor and Energy Harvesting Materials
- Wind Energy Research and Development
- Plant Molecular Biology Research
- Wave and Wind Energy Systems
- Steroid Chemistry and Biochemistry
- Natural Language Processing Techniques
Chongqing University
2023-2025
Ministry of Education
2025
Ningxia University
2024
Jiaxing University
2024
Henry Royce Institute
2023-2024
University of Manchester
2023-2024
Shanghai Institute of Technology
2022-2024
Guangzhou Panyu Polytechnic
2024
Shenzhen University
2024
Hunan University
2023
Novel out-of-autoclave (OoA) strategies for repairing carbon fibre reinforced plastics (CFRPs) were investigated to enable facile maintenance of components and, thus, reduce unnecessary scrappage. Oven cured GNPs/epoxy bulk and film nanocomposites first fabricated over a range GNPs loadings determine their percolation threshold Joule heating properties. Based upon these results, electrically conductive uncured with different then used as adhesives repair CFRPs through heat curing the network...
Mn oxides play a critical role in Tl scavenging and accumulation the epibiotic environment. However, effect of oxide reduction Mn/Fe cycle on mobilization is not clear. Herein, influence configuration, oxygen environment, degree MnO2 transformation associated species distribution investigated. In oxic environments, both typical δ-MnO2 α-MnO2 structures (i.e., layered tunneled, respectively) can immobilize Tl(I) for long time. mild-to-moderate reducing anoxic drastic reductive results...
Thallium (Tl) pollution from natural and anthropogenic sources is increasingly recognized for its environmental health risks, with localized threats in polluted areas despite low global background levels. Utilizing over 20,000 topsoil Tl measurements 21 related variables, a CatBoost classification model (AUC = 0.89, recall 0.80, balanced accuracy 0.84) was applied to predict whether concentrations exceeding 1 mg/kg, identifying both known unreported hotspots. A regression (R2 0.62) further...
Floating offshore wind turbines (FOWTs) are generally located in the harsh deep-sea environment and highly susceptible to extreme loads. In order ensure normal operation of FOWTs, this article takes semi-submersible FOWT as an example, proposes a new double-rope mooring system, studies dynamic performance with system its effectiveness reducing response turbine. At same time, tuned mass damper (TMD) is installed nacelle turbine, TMD parameters optimized considering space limitation by...
2D MXenes are well-known for their outstanding performance in electrochemical energy storage and many other applications owing to high conductivity specific surface area. An obstacle the wider synthesis of research industrial is use hazardous hydrofluoric acid (HF) during synthesis. Herein, we developed etching process Ti3C2 Ti3CN by using aqueous tetrafluoroboric as electrolyte, thus only involving a very low concentration HF. The effect electrical potential temperature on rate studied...
2D MXenes are well-known for their outstanding performance in electrochemical energy storage and many other applications owing to high conductivity specific surface area. An obstacle the wider synthesis of research industrial is use hazardous hydrofluoric acid (HF) during synthesis. Herein, we developed etching process Ti3C2 Ti3CN by using aqueous tetrafluoroboric as electrolyte, thus only involving a very low concentration HF. The effect electrical potential temperature on rate studied...
The potential of electrically conductive graphene nanoplatelets (GNPs)/epoxy, multi-walled carbon nanotubes (MWNCTs)/epoxy and hybrid GNPs-MWCNTs/epoxy nanocomposites as adhesives for out-of-autoclave (OoA) in-the-field CFRP repair via Joule heat curing was investigated. Scanning electron microscopy revealed a good dispersion the nanoparticles in matrix all nanocomposite above their percolation thresholds, which led to homogeneous distribution generated during repair. joints bonded with neat...
Abstract Phthalate esters (PAEs) raised serious concerns on their health risk due to toxicities. However, toxicities of low‐molecular‐weight PAEs, for example, dimethyl phthalates (DMPs), remained poorly investigated. In the present study, reproductive (o‐)phthalate (DMOP), (p‐)phthalate (DMPP), and (m‐)phthalate (DMMP) were measured Caenorhabditis elegans with mechanical exploration. Results showed that DMPP, DMOP, DMMP commonly inhibited total reproduction while stimulated lifespan,...
To date, most of the reported piezoelectric energy harvesters (PEHs) use lead-based Pb(Zr,Ti)O3 (PZT) piezoceramic family, which is obviously harmful to environment. In recent years, PEHs constructed with lead-free piezoceramics have been developed rapidly. However, their force-to-electric (F–E) output performances are still unsatisfactory. address this issue, here we present a PEH assembled potassium sodium niobate (KNN) based co-fired multilayered (MLPCs), show high current and power....