A5100432600- Titanium Alloys Microstructure and Properties
- Microstructure and mechanical properties
- Aluminum Alloy Microstructure Properties
- Intermetallics and Advanced Alloy Properties
- Aluminum Alloys Composites Properties
- Advanced materials and composites
- Metallurgy and Material Forming
- Corrosion Behavior and Inhibition
- Tunneling and Rock Mechanics
- Hydrogen embrittlement and corrosion behaviors in metals
- Mechanical Behavior of Composites
- Granular flow and fluidized beds
- Additive Manufacturing Materials and Processes
- Microstructure and Mechanical Properties of Steels
- Tribology and Wear Analysis
- Forensic Entomology and Diptera Studies
- Metal Forming Simulation Techniques
- Metal and Thin Film Mechanics
- Advanced ceramic materials synthesis
- Geotechnical and Geomechanical Engineering
- Advanced machining processes and optimization
- Advanced Sensor and Control Systems
- Anodic Oxide Films and Nanostructures
- Advanced Manufacturing and Logistics Optimization
- Dielectric materials and actuators
Northwestern Polytechnical University
2024
Jiangsu Academy of Agricultural Sciences
2024
Xi'an Jiaotong University
2024
Central South University
2006-2022
Education Department of Hunan Province
2022
Changsha University of Science and Technology
2022
Nanshan Group (China)
2022
University of Science and Technology Liaoning
2022
Hunan University of Humanities, Science and Technology
2022
State Key Laboratory of High Performance Complex Manufacturing
2022
Abstract Developing self‐oscillating soft actuators that enable autonomous, continuous, and directional locomotion is significant in biomimetic robotics fields, but remains great challenging. Here, an untethered photoactuators based on covalently‐bridged black phosphorus‐carbon nanotubes heterostructure with self‐oscillation phototactic under constant light irradiation designed. Owing to the good photothermal effect of phosphorus thermal deformation actuator components, new assembled by...
A new thermomechanical process was applied to a near-β Ti-5Al-5Mo-5V-1Cr-1Fe alloy induce twinning. The resulting combination of ultrafine grains and heat-treatment twins endowed the with excellent tensile strength (1544 MPa) elongation (13%). β-Field cross-rolling formed micro-sized β grains, α particles precipitated from pre-existing dense dislocation structures martensites. α-Twinning occurred during heat treatment continuously evolved ongoing time. precisely controlled time enabled...
Detailed tests and characterizations were used to investigate the corrosion degradation behaviors of Ti6Al4V alloys in simulated marine environments. These suffered from very slight pitting a miniscule weight loss 0.018 mg/cm2 during 50 cycle salt spray exposure but experienced significant oxygen erosion high-temperature oxidation test, resulting high gain 2.657 at 400 h. The reactions simultaneously occurred hot test. chlorine (Cl2) induced by eutectic reaction mixed salts accelerated...