A5000123261- Oceanographic and Atmospheric Processes
- Environmental and Agricultural Sciences
- Conducting polymers and applications
- Climate variability and models
- Meteorological Phenomena and Simulations
- Ocean Waves and Remote Sensing
- Polymer Surface Interaction Studies
- Tropical and Extratropical Cyclones Research
- Reservoir Engineering and Simulation Methods
- Electrochemical sensors and biosensors
- Advanced Sensor and Energy Harvesting Materials
- Dielectric materials and actuators
- Reliability and Maintenance Optimization
- Coagulation and Flocculation Studies
- Global Energy and Sustainability Research
- Hydrology and Watershed Management Studies
- Heavy metals in environment
- Advanced biosensing and bioanalysis techniques
- Adsorption and biosorption for pollutant removal
- Luminescence and Fluorescent Materials
- Advanced Nanomaterials in Catalysis
- Arsenic contamination and mitigation
- Statistical Distribution Estimation and Applications
- Environmental and Sediment Control
- Atmospheric and Environmental Gas Dynamics
Jiamusi University
2017-2025
University of Alabama
2024
Shijiazhuang University
2023
Chongqing University of Technology
2023
Beijing Institute of Technology
2023
Tianjin University of Science and Technology
2023
Beijing Technology and Business University
2022-2023
PLA Army Engineering University
2023
Tongji University
2018-2021
State Key Laboratory of Pollution Control and Resource Reuse
2018-2020
Abstract The National Weather Service (NWS) Office of Water Prediction (OWP), in conjunction with the Center for Atmospheric Research and NWS Centers Environmental (NCEP) implemented version 2.1 Model (NWM) into operations April 2021. As initial 2016, NWM v2.1 is an hourly cycling analysis forecast system that provides streamflow guidance millions river reaches other hydrologic information on high‐resolution grids. complementary at current locations significantly expands coverage water...
Abstract A high‐resolution three‐dimensional Weather Research and Forecasting (WRF) model is used to investigate the coupled impact of lake surface temperature (LST) wind on effect snow (LES) over Great Lakes region. set twin WRF simulations, with without resolving LST spatial variations in model's boundary condition, performed quantify variation LES. Both observations results reveal a positive correlation between downwind gradient convergence Furthermore, simulations show that increases...
A copper-based nanoenzyme (Cu-BL) co-modified by L-L-lysine and 2-2-amino terephthalic acid has laccase-like activity fluorescence characteristics. Based on this, a colorimetric fluorescent dual-mode sensor was developed to visually quantitatively detect tetracycline antibiotics (TCs), including (TC), chlortetracycline (CTC), oxytetracycline (OTC). In the detection system, TCs can inhibit generation of singlet oxygen (1O2) weaken ability 2,4-dichlorophenol (2,4-DP) be oxidized into...
Summary There is limited information on zinc ( Zn 2+ ) adsorption and desorption by different types of soil, especially acidic ones following amendment with manure‐ lignocellulose‐derived biochars. The novelty this research a comparison the mechanisms soil amended biochar derived from either swine manure or rape straw. Both biochars were prepared at pyrolysis temperature 500°C before being incorporated into four low pH H2O 4.61 to 5.91) an incorporation rate 3%. Following incubation for 360...
This study provides the first detailed analysis of oceanic and atmospheric responses to current-stress, wave-stress, wave-current-stress interactions around Gulf Stream using a high-resolution three-way coupled regional modeling system. In general, our results highlight substantial impact coupling currents and/or waves with wind stress on air–sea fluxes over Stream. The curl are crucial mixed-layer energy budgets sea surface temperature. experiment, increased by 15% Alternating positive...
Cellulose filter aid (CFA), a skeleton builder, has been studied for sludge conditioning at laboratory scale because of its function in reducing compressibility cake. However, there are few practical applications CFA the pilot and factory scales. In this study, we combined with an advanced dewatering technology, applications. For jar test, optimum dose was 3 wt.% dry solid (DS); furthermore, combination polyaluminum chloride (PAC) polyacrylamide (PAM) resulted lowest moisture content...
Epoxy resin/polyetherimide/graphene nanoplates (EP/PEI/GnPs) composites were prepared by solution blending, and the effects of GnPs on phase structure electrical properties systems investigated scanning electron microscopy (SEM), optical (OM), digital ultrahigh resistance microcurrent measuring meter precision impedance analyzer.The results show that separation morphology change from sea-island to bicontinuous inversion with increase content.The have an percolation threshold 0.85 wt%.A high...
A bioinspired ionic hydrogel-based antifouling material with excellent adaptability has been constructed, featured ultralow adhesion to various solid/viscous liquid deposition, high conductivity, and mechanical properties.
To reduce the risk of infection, improving anti-infection ability Ti-based implantation has become a very meaningful task. In this work, by employing polydopamine (PDA) as carrier and curcumin (CUR) an anti-biotic/inflammatory, series Ti-PDA@CURx (x = 0.5, 1.0, 1.5, 2.0, 2.5) was successfully fabricated characterized scanning electron microscopy, Fourier transform infrared spectrometry, X-ray diffraction, photoelectron spectroscopy, water contact angle, where Ti plates were firmly coated...
The accurate pretreatment, solving and post-treatment of composite insulators were completed based on finite-element method ,and the distribution surface electric field intensity was drawn in this paper at first. And then,the factors that influence analyzed, radiuses umbrella skirt selected as optimization variables, two objective function defined to make more uniform. structure design simplified model insulator using modules parametric analysis single genetic algorithm. Finally, both...