A5013654224- Air Quality and Health Impacts
- Atmospheric chemistry and aerosols
- Air Quality Monitoring and Forecasting
- Atmospheric and Environmental Gas Dynamics
- Vehicle emissions and performance
- Climate Change and Health Impacts
- Insect-Plant Interactions and Control
- Hymenoptera taxonomy and phylogeny
- Atmospheric aerosols and clouds
- Climate variability and models
- Fire effects on ecosystems
- Insect behavior and control techniques
- Wind and Air Flow Studies
- Water resources management and optimization
- COVID-19 impact on air quality
- Flood Risk Assessment and Management
- Global Health Care Issues
- Spatial and Panel Data Analysis
- Marine and coastal ecosystems
- Water Quality and Pollution Assessment
- Target Tracking and Data Fusion in Sensor Networks
- Water Quality Monitoring and Analysis
- Phytochemical compounds biological activities
- Atmospheric Ozone and Climate
- Smart Materials for Construction
Le Quy Don Technical University
2025
NSW Department of Climate Change, Energy, the Environment and Water
2024
NSW Department of Planning and Environment
2009-2024
Van Lang University
2023-2024
TU Bergakademie Freiberg
2024
Department of Climate Change, Energy, the Environment and Water
2024
Ton Duc Thang University
2015-2023
Vietnam Academy of Science and Technology
2023
Hội Gastroenterology Việt Nam
2023
Vietnam National University, Hanoi
2023
The 2019–2020 summer wildfire event on the east coast of Australia was a series major wildfires occurring from November 2019 to end January 2020 across states Queensland, New South Wales (NSW), Victoria and Australia. were unprecedent in scope extensive character caused smoke pollutants be transported not only Zealand, but also Pacific Ocean America. At peak wildfires, plumes injected into stratosphere at height up 25 km hence globe. meteorological air quality Weather Research Forecasting...
This paper presents optimization results of the Al6061 surface roughness in turning ultra-precision based on central composite design method (CCD) and grey wolf algorithm (GWO). The experimental matrix is built with three independent variables including spindle speed, feed rate depth cut. With data, regression model established. ANOVA module used to evaluate quality model. GWO optimize within range pre-determined cutting conditions. most reasonable parameter set found ensure that material...
The small microgastrine genus Philoplitis Nixon, 1965 from Vietnam is newly recorded. As a result, two new species are described and fully illustrated, viz. ipunctatus Long, sp. nov. cariniferus nov.. Additionally, the recorded for first time Vietnam, comparative characters of summarized in table.
This paper presents a summary of the key findings special issue Atmosphere on Air Quality in New South Wales and discusses implications work for policy makers individuals. edition new air quality research Australia undertaken by (or association with) Clean Urban Landscapes hub, which is funded National Environmental Science Program behalf Australian Government’s Department Environment Energy. pollution cities generally low, with typical concentrations pollutants at much lower levels than...
Along with its rapid urban development, Ho Chi Minh City (HCMC) in recent years has suffered a high concentration of air pollutants, especially fine particulate matters or PM2.5. A comprehensive study is required to evaluate the quality conditions and their health impact this city. Given lack adequate monitoring data over large area size HCMC, an modeling methodology adopted address requirement. Here, by utilizing corresponding emission inventory combination The Air Pollution Model-Chemical...
This paper presents a data fusion framework to enhance the accuracy of air-pollutant forecast in state New South Wales (NSW), Australia using deep learning (DL) as core model. Here, we propose long short-term memory Bayesian neural network (LSTM-BNN) improve performance predictive profiles via quantifying uncertainties and adjusting model parameters. For this, develop new inferring technique for kernel density estimation with subdivision tuning ensure both computational efficiency limited...
Abstract Background Rate models for predicting vehicular emissions of nitrogen oxides (NO X ) are insensitive to the vehicle modes operation, such as cruise, acceleration, deceleration and idle, because these usually based on average trip speed. This study demonstrates feasibility using other variables speed, load, power ambient temperature predict ensure that emission inventory is accurate hence air quality modelling management plans designed implemented appropriately. Methods We propose...
It is essential to maintain air-quality standards and take necessary measures when air-pollutant concentrations exceed permissible limits. Pollutants such as ground-level ozone (O <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sub> ), nitrogen oxides (NOX), volatile organic compounds (VOCs) emitted from various sources can be estimated at a particular location through integration of observation data obtained measurement sites effective...
We propose a new technique to prepare statistically-robust benchmarking data for evaluating chemical transport model meteorology and air quality parameters within the urban boundary layer. The approach employs atmospheric class-typing, using nocturnal radon measurements assign mixing classes, can be applied temporally (across diurnal cycle), or spatially (to create angular distributions of pollutants as top-down constraint on emissions inventories). In this study only short (<1-month)...
The coupled Conformal Cubic Atmospheric Model (CCAM) and Chemical Transport (CTM) (CCAM-CTM) was undertaken with eleven emission scenarios segregated from the 2008 New South Wales Greater Metropolitan Region (NSW GMR) Air Emission Inventory to predict major source contributions ambient PM2.5 exposure in NSW GMR. results illustrate that populated areas GMR are characterised annual average of 6–7 µg/m3, while natural sources including biogenic emissions, sea salt wind-blown dust contribute 2–4...
Between 11 and 15 February 2019, a dust storm originating in Central Australia with persistent westerly south winds caused high particle concentrations at many sites the state of New South Wales (NSW); both inland along coast. The continued to be transported Zealand Antarctica east. This study uses observed data WRF-Chem Weather Research Forecast model based on GOCART-AFWA (Goddard Chemistry Aerosol Radiation Transport–Air Force Agency) scheme GOCART aerosol gas-phase MOZART (Model for Ozone...
The ability of meteorological models to accurately characterise regional meteorology plays a crucial role in the performance photochemical simulations air pollution. As part research funded by Australian government’s Department Environment Clean Air and Urban Landscape hub, this study set out complete an intercomparison quality over Sydney region. This would test existing modelling capabilities, identify any problems provide necessary validation first component was assess reproduce...
In early 2020 from April to June, the metropolitan area of Sydney as well rest New South Wales (NSW, Australia) experienced a period lockdown prevent spread COVID-19 virus in community. The effect reducing anthropogenic activities including transportation had an impact on urban environment terms air quality which is shown have improved for number pollutants, such Nitrogen Dioxides (NO2) and Carbon Monoxide (CO), based monitoring data ground satellite. addition primary pollutants CO NOx...
The Upper Hunter Valley is a major coal mining area containing approximately 40% of the currently identified total reserves in New South Wales (NSW), Australia. Due to ongoing increase activities, PM10 (air-borne particle with an aerodynamic diameter less than 10 micrometres) pollution has become air quality concern local communities. This paper summarises spatial and temporal variability modes region, based on long-term multi-site monitoring data application rotated principal component...
Poor air quality is often associated with hot weather, but the quantitative attribution of high temperatures on remains unclear. In this study, effect elevated investigated in Greater Sydney using January 2013, a period extreme heat during which at times exceeded 40 °C, as case study. Using observations from 17 measurement sites and Weather Research Forecasting Chemistry (WRF-Chem) model, we analyse ozone by running number sensitivity studies which: (1) model run biogenic emissions generated...