Xiaoqing Yuan

ORCID: 0000-0002-8323-2434
Publications
Citations
Views
---
Saved
---
About
Contact & Profiles
Research Areas
  • High voltage insulation and dielectric phenomena
  • Aerosol Filtration and Electrostatic Precipitation
  • Crystallization and Solubility Studies
  • X-ray Diffraction in Crystallography
  • Silicone and Siloxane Chemistry
  • Thermal Analysis in Power Transmission
  • Ionic liquids properties and applications
  • Surface Modification and Superhydrophobicity
  • Advanced Sensor and Energy Harvesting Materials
  • Dielectric materials and actuators
  • Chromium effects and bioremediation
  • Plasma Applications and Diagnostics
  • Carbon dioxide utilization in catalysis
  • Power Line Inspection Robots
  • Electrical Fault Detection and Protection
  • Polysaccharides and Plant Cell Walls
  • Electrowetting and Microfluidic Technologies
  • Conducting polymers and applications
  • Surfactants and Colloidal Systems
  • Inorganic Chemistry and Materials
  • High-Velocity Impact and Material Behavior
  • Pickering emulsions and particle stabilization
  • Adsorption and biosorption for pollutant removal
  • Diamond and Carbon-based Materials Research
  • Carbon Dioxide Capture Technologies

Hunan Agricultural University
2023-2024

Guizhou Electric Power Design and Research Institute
2018-2023

Institute of Process Engineering
2021-2022

University of Chinese Academy of Sciences
2022

Wuhan University
2016-2018

Henan Normal University
2018

Henan University
2018

Nankai University
2014

Fujian Institute of Research on the Structure of Matter
2010

Room temperature vulcanized (RTV) silicone rubber is extensively used in power system due to its hydrophobicity and transfer ability. Temperature has been proven markedly affect the performance of rubbers. This research investigated degradation RTV under cycling treatment. Hydrophobicity ability, hardness, functional groups, microscopic appearance, thermal stability were analyzed using static contact angle method, a Shore A durometer, Fourier transform infrared spectroscopy (FTIR), scanning...

10.3390/en10071054 article EN cc-by Energies 2017-07-21

Photo-induced conductivity modulation of stimuli-responsive materials is great importance from the viewpoint fundamental research and technology. In this work, 5 new kinds azobenzene-based photo-responsive ionic liquids were synthesized characterized, UV/vis light their was investigated in an aqueous solution. The factors affecting fluids, such as photo-isomerization efficiency, photo-regulation aggregation, concentration chemical structure liquids, examined systematically. It found that...

10.1039/c8cp01617h article EN Physical Chemistry Chemical Physics 2018-01-01

In order to study the difference in performance of room temperature vulcanized (RTV) silicone rubber vulcanization environment with different and humidity, static contact angle method, FTIR TG is utilized depict properties hydrophobicity, transfer functional groups thermal stability RTV rubber. It found that conditions have effects on characteristics rubber, which shows hydrophobicity changes little but a slight increase humidity. Temperature humidity obvious ability better when 5°C or 95%....

10.1088/1757-899x/207/1/012011 article EN IOP Conference Series Materials Science and Engineering 2017-06-01

PEDOT has been widely used in advanced electronics, and one of the keys to determine performance is hole mobility.

10.1039/d1ta08013j article EN Journal of Materials Chemistry A 2021-01-01

Humidity is a critical factor in atmospheric corona discharge. Fluid dynamics models have become common method to explore the detailed discharge characteristics humid air. However, require specification of some key parameters, such as electron swarm parameters and Townsend coefficients, which strongly depend on energy distribution function (EEDF). In this paper, EEDFs dry air water vapor are compared by solving Boltzmann equation using classical two-term approximation. Moreover, drift...

10.1063/1.5025116 article EN Physics of Plasmas 2018-06-01

Atmospheric corona discharge plasmas are the most common diversely occurrence in electric power system. In this paper, four elementary processes occurred taken into account, including elastic collision, excitation, attachment, and ionization. As one of important parameters characteristics analysis, effective Townsend ionization coefficient is completely calculated by Boltzmann equation under consideration humidity. This paper also derives electron energy distribution function (EEDF) water...

10.1109/tps.2016.2623805 article EN IEEE Transactions on Plasma Science 2016-11-16

Concerns over the operation safety of power transformers have triggered an application room temperature vulcanized (RTV) silicone rubber on transformer bushings. However, oil may cause a severe deterioration in performance RTV coatings due to leakage. Little attention has been paid degradation oil. This paper presents experimental investigation explore An immersion experiment is performed. Mass, hardness and hydrophobicity are analyzed research macro properties rubbers. FTIR, XPS SEM...

10.1109/tdei.2017.006497 article EN IEEE Transactions on Dielectrics and Electrical Insulation 2017-01-01

Room temperature vulcanized (RTV) silicone rubber is widely used in external insulation of electrical equipment for antipollution flashover because it has many merits such as superior hydrophobicity and migration hydrophobicity, but also weakness poor aging performance. The study on the failure criterion RTV always a concern since there been no generally accepted method its criterion. Corona an important effect recovery performance rubber. In this paper, tests were conducted to reveal corona...

10.1109/eic.2016.7548698 article EN 2016-06-01

Room temperature vulcanized (RTV) silicone rubber is widely used to prevent pollution flashover with its excellent hydrophobicity and transfer.However, RTV coatings are at the risk of deterioration failure in heavily polluted operating environment.In this paper, coated insulators different suspension heights coal ash areas were sampled.Pollution degree, composition aging degree tested.The result shows that insoluble contains Al(OH) 3 filler precipitated from coating, which indicates...

10.24425/aee.2020.131757 article EN cc-by-nc-nd Archives of Electrical Engineering 2023-04-03

The composition of metallurgical contamination is rather special, which has a great influence on the accumulation and flashover characteristics insulators. In this study, 500 kV AC line insulators in industry area central China were sampled. ion composition, element micromorphology particle size distribution at high low end insulator string tested, respectively. equivalent salt deposit density (ESDD) non‐soluble (NSDD) high‐voltage end, low‐voltage middle segment three‐phase strings tested....

10.1049/iet-smt.2018.5099 article EN IET Science Measurement & Technology 2019-02-28

The performance of room temperature vulcanized (RTV) silicone rubber under various operation conditions is always a hot point in the study external insulation. influences transformer oil on RTV have been little investigated, which are crucial issues for covering bushing because potential leakage problems. In present work, immersion experiment applied to explore rubber. Samples immersed into at 70 °C and 110 4, 8, 24, 72, 168 336hrs, respectively. They analyzed by contact angle measurement...

10.1109/ichve.2016.7800779 article EN 2016-09-01

The metallurgical industry in China has developed rapidly, which caused an increasing amount of exhausted gas emission. After a long period operation, layer contamination is deposited on the surface insulators near metal work, may have effect distribution electric field insulator. chemical test indicates that contains particles Fe3O4 with strong conductivity, become suspended potential conductor. In this paper, influence thickness and diameter, arrangement conductive are discussed by...

10.1088/1757-899x/366/1/012071 article EN IOP Conference Series Materials Science and Engineering 2018-06-01

An emergency frequency control strategy using demand response based on deep reinforcement learning is proposed. According to the system before and after fault, used predict amount of load shedding by trained prediction model. Firstly, genetic algorithm optimize multi-objective function optimal load-shedding fault target power grid. Q-learning establish action mapping relationship between response, so as obtain sample data. After training data convolutional neural network (CNN), a model...

10.1109/appeec48164.2020.9220600 article EN 2020-09-01

Abstract The new isostructural compounds (III), (V), and (VI) crystallize in the orthorhombic space group Cmcm with Z = 4 (single crystal XRD).

10.1002/chin.201051014 article EN ChemInform 2010-11-26
Coming Soon ...