A5100706217- Phase Equilibria and Thermodynamics
- Chemical Thermodynamics and Molecular Structure
- Refrigeration and Air Conditioning Technologies
- Topology Optimization in Engineering
- Composite Structure Analysis and Optimization
- Thermodynamic properties of mixtures
- Model Reduction and Neural Networks
- Maritime Navigation and Safety
- Safety and Risk Management
- Piezoelectric Actuators and Control
- Advanced Battery Technologies Research
- Advanced Multi-Objective Optimization Algorithms
- Heat Transfer and Optimization
- High-Temperature Coating Behaviors
- Electric Vehicles and Infrastructure
- Probabilistic and Robust Engineering Design
- Electric and Hybrid Vehicle Technologies
- Heat Transfer and Boiling Studies
- Robotic Path Planning Algorithms
- Civil and Geotechnical Engineering Research
- Geotechnical and Geomechanical Engineering
- Smart Grid and Power Systems
- Underwater Vehicles and Communication Systems
- Energetic Materials and Combustion
- Power Systems and Technologies
Tsinghua University
2019-2024
Beijing Institute of Technology
2023-2024
Hunan University
2023-2024
Chongqing University
2021
Zhejiang University
2021
Wuhan University of Technology
2018
China University of Labor Relations
2017
The University of Tokyo
2010
In this work, 95 data points for the vapor pressure of trans-1-chloro-3,3,3-trifluoroprop-1-ene (HCFO-1233zd(E)) were measured over temperature range 253–431 K and 17–3091 kPa using a Burnett apparatus. The effect presence impurities on measurement was carefully analyzed, deviations caused by corrected. detailed uncertainty analysis presented, combined expanded (k = 2) in is 6.2 mK; ranged from 0.33 to 1.18 kPa. A Wagner-type equation developed based work those literature. normal boiling...
In this work, 91 vapor pressure data of cis-1,1,1,4,4,4-hexafluoro-2-butene (HFO-1336mzz(Z)) were measured using a Burnett apparatus in temperature range (278 to 443) K and (30 2830) kPa. The sample was analyzed by gas chromatography with mass spectrometry, the deviations caused impurities corrected based on ideal solution model. combined expanded (k = 2) uncertainty measurement is 6.2 mK, (0.30 0.90) On basis literature experimental new Wagner-type equation used correlate data. normal...
In some scenarios, electric heavy-duty trucks with battery swapping mode (ETBSm) are more cost-effective than charging mode. The viability of stations is contingent upon the operational requirements and range capabilities ETBSm. Low temperatures have effect reducing ETBSm, thereby creating difficulties for swapping. This article proposes use motor waste heat recovery (MWHR) to batteries, which would improve range. A number subsystem models been established, including battery, motor, thermal...
This paper proposes a relative navigation method for an underwater vehicle around hydrothermal chimneys. Hydrothermal vent areas are scientifically important geological, chemical and biological research in deep oceans. Especially, investigation of chimneys is essential to reveal their mechanisms. The enables go observe such three-dimensional natural structures. In the we determine vehicle's position angle structure real-time, based on light-sectioning technique using its camera sheet laser....
Accidents happened in wind power enterprises can lead to severe consequences. Based on the statistical analysis collection of accident world for nearly 20 years, proportion accidents' type be discovered. With SWOT method and AHP analytic hierarchy process, risk evaluation model, judgment matrix weight each factor established. Take company as an example, human is determined most significant it's safe production. Afterwards, using Monte Carlo simulate, operate, count results...
Abstract In gradient-based time-domaintopology optimization, Design Sensitivity Analysis (DSA) of the dynamic response is essential, and requires high computational cost to directly differentiate, especially for high-order system. To address this issue, study develops an efficient Reduced Basis Method(RBM)-based discrete adjoint sensitivity analysis method, which on one hand significantly improves efficiency other avoids consistency errors caused by continuum method. algorithm, basis...
The concurrent optimization of topology and fibre orientation is a promising approach to pursue higher strength lighter weight variable-stiffness structure. This study proposes novel discrete-continuous scheme for the optimization. Considering global convergence, Discrete Material Optimization (DMO) firstly utilized select dominant angle each element from several predefined candidate angles. However, it still difficult obtain excellent convergence due difficulty in selection materials some...
Industrial induction heating has much possibility in wide range of industries due to its high performance and efficiency. Dual-frequency is becoming promising power supply as it helpful for obtaining better surface hardening workpieces with irregular shape. Conventional method obtain dual-frequency couple two full-bridge inverters' outputs different frequencies through a transformer. However, redundancy increase volume cost. Topology single inversion cost-effective solution. Con-sidering...