A5100714479- Wind Energy Research and Development
- Fluid Dynamics and Vibration Analysis
- Wave and Wind Energy Systems
- Titanium Alloys Microstructure and Properties
- Welding Techniques and Residual Stresses
- Advanced Welding Techniques Analysis
- Recycling and utilization of industrial and municipal waste in materials production
- Fluid Dynamics and Turbulent Flows
- Advancements in Battery Materials
- Concrete and Cement Materials Research
- Advanced Battery Materials and Technologies
- Aerodynamics and Acoustics in Jet Flows
- Aerodynamics and Fluid Dynamics Research
- Metal and Thin Film Mechanics
- Advanced materials and composites
- Smart Grid and Power Systems
- Intermetallics and Advanced Alloy Properties
- Power Systems and Technologies
- Wind and Air Flow Studies
- Orthopaedic implants and arthroplasty
- Advanced Battery Technologies Research
- Power Line Inspection Robots
- Plasma and Flow Control in Aerodynamics
- High-Voltage Power Transmission Systems
- Aerospace Engineering and Energy Systems
Sichuan University
2023-2024
Liverpool John Moores University
2023-2024
Chongqing University
2024
Civil Aviation Flight University of China
2024
China General Nuclear Power Corporation (China)
2020-2024
Sanya University
2024
University of Shanghai for Science and Technology
2020-2023
Central South University
2022-2023
State Key Laboratory of High Performance Complex Manufacturing
2023
Fudan University
2019-2023
Surface topography is a biophysical factor affecting cell behaviors, yet the underlying cues are still not clear. Herein, we hypothesized that stereo coverage and overall stiffness of biomaterial arrays on scale single cells underly parts effects adhesion. We fabricated series microarrays (micropillar, micropit, microtube) poly(l-lactic acid) (PLLA) using mold casting based pre-designed templates. The characteristic sizes array units were less than cell, thus, each could sense micropatterns...
While various porous scaffolds have been developed, the focused study about which structure leads to better mechanics is rare. In this study, we designed with tetragonal, hexagonal and wheel-like structures under a given porosity, fabricated corresponding poly(lactic acid) (PLA) three-dimensional printing. High-resolution micro-computed tomography was carried out calculate their experimental porosity confirm high interconnectivity. The theoretical compressive properties in longitudinal...
Polyolefin separators are the most commonly used for lithium batteries; however, they tend to shrink when heated, and their Li
In this work, to explore potential substitutions for the Co binder phase, ultrafine-grain WC-based cermets with various phases of Co, Ni and AlCoCrNiFeCu HEA were prepared using SPS method. Based on SPS, fabricated at higher speed, showing fine carbide particles less than 410 μm. The microstructure, mechanical properties wear systematically evaluated. By comparison, grain size WC was lowest WC-10Co, while WC-10 cermet held coarsest particles. hardness fracture toughness best among all three...