A5056141336- Aluminum Alloys Composites Properties
- High Temperature Alloys and Creep
- Aluminum Alloy Microstructure Properties
- Cellular and Composite Structures
- Intermetallics and Advanced Alloy Properties
- Magnesium Alloys: Properties and Applications
- Microstructure and mechanical properties
- Metallurgy and Material Forming
- Corrosion Behavior and Inhibition
- Advanced Materials Characterization Techniques
- High-Temperature Coating Behaviors
- Polymer Foaming and Composites
- Polymer composites and self-healing
- High Entropy Alloys Studies
- Advanced materials and composites
- Metallurgical and Alloy Processes
- Solidification and crystal growth phenomena
- Metal Alloys Wear and Properties
- Acoustic Wave Phenomena Research
- Microstructure and Mechanical Properties of Steels
- Electromagnetic wave absorption materials
- Bauxite Residue and Utilization
- Mechanical Behavior of Composites
- Fluid Dynamics Simulations and Interactions
- Pickering emulsions and particle stabilization
Hebei University of Technology
2016-2025
Tianjin University
2017-2021
Applied Materials (United States)
2012
Concordia University
1995
In our current work, AZ31 magnesium alloy foams with closed-cell were successfully fabricated by melt foaming method using Ca and CaCO3 as thickening blowing agent, respectively. The influences of porosity pore size on the quasi-static compressive properties systematically investigated. results showed that yield strength, energy absorption capacity ideality efficiency decreased increase in porosity. However, specimens porosities 60%, 65% 70% possessed similar total efficiency. Meanwhile,...
In the course of service, integral-forming aluminum foam sandwich (IFAFS) needed to bear three-point bending loads in different directions, however, its deformation mechanism and failure modes were still unclear. this work, performances IFAFS under flatwise edgewise conditions investigated by experiment, in-situ micro X-ray tomography digital volume correlation (DVC) calculation. The results showed that performance was more stable condition, with decrease span length presented three oblique...
The incorporation of a homogeneously distributed nanocrystalline phase in Fe-based amorphous coatings is widely acknowledged to enhance wear resistance across various applications. In this study, FeCrMoWBRE amorphous/nanocrystalline composite were fabricated on 45# steel substrates using high-velocity arc spraying (HVAS). produced under varying voltages, currents, and distances, following the Taguchi experimental design methodology. microstructure, mechanical properties, systematically...
Given the widespread applications of aluminum foams, they inevitably undergo cyclic compressive loading during service, and therefore, it is necessary to study their compression fatigue properties. In this work, closed‐cell alloy foams (CAAF) are obtained by two‐step foaming method with A356 as matrix alloy. Pore structures quasistatic properties foam first analyzed. Subsequently, effect stress level porosity on compression–compression performances CAAF investigated based results. The...