A5062146627- Advanced materials and composites
- Fusion materials and technologies
- Metal and Thin Film Mechanics
- X-ray Diffraction in Crystallography
- Crystallization and Solubility Studies
- Nuclear Materials and Properties
- Diamond and Carbon-based Materials Research
- High Entropy Alloys Studies
- Advanced Photocatalysis Techniques
- High-Temperature Coating Behaviors
- Electrocatalysts for Energy Conversion
- Titanium Alloys Microstructure and Properties
- Water resources management and optimization
- Electromagnetic wave absorption materials
- Semiconductor materials and devices
- Metallic Glasses and Amorphous Alloys
- Natural Fiber Reinforced Composites
- Advanced ceramic materials synthesis
- Advanced Nanomaterials in Catalysis
- Metal-Organic Frameworks: Synthesis and Applications
- nanoparticles nucleation surface interactions
- Metal Alloys Wear and Properties
- Additive Manufacturing Materials and Processes
- Fuel Cells and Related Materials
- Machine Learning in Materials Science
Panzhihua University
2019-2024
Shanghai Institute of Applied Physics
2024
Chinese Academy of Sciences
2012-2024
Shanghai University of Engineering Science
2024
Nanjing Forestry University
2024
Nantong University
2024
Aerospace Center Hospital
2023
Daqing Oilfield General Hospital
2023
Viva Biotech (China)
2023
State Council of the People's Republic of China
2019-2020
MoS<sub>2</sub> nanodot decorated In<sub>2</sub>S<sub>3</sub> nanoplates were successfully synthesized <italic>via</italic> a modified one-pot method.
In order to enhance the anti-wear ability and conductive performances of frictional materials under current-carrying friction, approach combining ZrN film graphene grease was proposed. The surface chemical composition were detected, measured. anti-friction lubrication also tested. results suggested that had a uniform distribution Zr N content, increasing content raised electrical conductivity lubricating grease. tribological tests showed friction pair at 0.3 wt% lowest average coefficient...
Black TiO2 has attracted widespread attention due to its visible light absorption and wide range of applications. However, the currently reported preparation methods for black are not suitable large-scale production being prepared under high vacuum over a long time. We have successfully normal pressure short time conditions. The as-prepared titanium dioxide was characterized by XRD, XPS, TEM, UV-visible spectrum other characterization methods. result shows that as had disordered structure...
The introduction of Ni(OH)<sub>2</sub> improved the electrocatalytic performance Pt/Ni(OH)<sub>2</sub>/N–CNTs for MOR <italic>via</italic> accelerating water dissociation and oxidizing carbonaceous poison.
Bulk metallic glasses (BMGs) are usually brittle, and show serious negative strain rate sensitivity upon dynamic loading due to no sufficient time for generation of the shear bands, which fatally limit their practical applications. Investigations have been done on BMGs deformation behaviors, but in yielding phenomenon was hardly reported before. In this work, by raising stored energy appears as an exothermic heat relaxation heating glass, quasi-static behaviors Cu45.75Zr46.75Al6.5Co1 BMG...
Single-phase body-centered cubic (BCC) lightweight Ti-V-Nb-Zrx solid-solution alloys were fabricated by reducing the Zr concentration within range of 0–5 at% to improve mechanical properties equimolar TiVNbZr alloy at elevated temperatures. The Zrx indeed exhibited greater strength above 800 °C than TiVNbZr, but some special responses occurred °C: (ⅰ) superficial cracks with different lengths and amounts along high-angle grain boundaries (HAGBs) on compressed sample surface, (ⅱ) near-brittle...
Background: Meloxicam is a selective cyclooxygenase-2 inhibitor used for pain relief, but its poor solubility limits clinical applications. QP001 novel intravenous formulation of meloxicam developed with PEG and pH regulator to improve solubility. This study aimed evaluate the safety, tolerability, pharmacokinetics in Chinese healthy subjects. Methods: The trial consisted three parts. Part I was two-period crossover bioavailability, which 10 were either intravenously infused 15mg (test) or...
Experimental and theoretical studies on the compositional changes of new particle formation in nucleation initial growth stages acid–base systems (2 5 nm) are extremely challenging. This study proposes a machine learning method for predicting composition change sulfuric acid-dimethylamine system transformation from monomer to nanoparticle by structure information small-sized acid (SA)–dimethylamine (DMA) molecular clusters. Based this components, we found that was mainly through alternate...