A5086137645- Metallic Glasses and Amorphous Alloys
- Glass properties and applications
- Material Dynamics and Properties
- Phase-change materials and chalcogenides
- Gas Sensing Nanomaterials and Sensors
- Advanced Chemical Sensor Technologies
- Electrochemical Analysis and Applications
- Analytical Chemistry and Sensors
- High Entropy Alloys Studies
- Solidification and crystal growth phenomena
- X-ray Diffraction in Crystallography
- High-Temperature Coating Behaviors
- Molecular Junctions and Nanostructures
- Corrosion Behavior and Inhibition
- Crystallization and Solubility Studies
- Hydrogen embrittlement and corrosion behaviors in metals
- Electronic Packaging and Soldering Technologies
- Ginseng Biological Effects and Applications
- Neurobiology and Insect Physiology Research
- Electrocatalysts for Energy Conversion
- Fatigue and fracture mechanics
- Advanced Computational Techniques and Applications
- Electric and Hybrid Vehicle Technologies
- Pneumocystis jirovecii pneumonia detection and treatment
- TiO2 Photocatalysis and Solar Cells
Nanchang Hangkong University
2022
Taishan University
2016-2021
Luoyang Institute of Science and Technology
2020
Dalian Maritime University
2016-2017
Hefei University of Technology
2010-2016
Wenzhou Medical University
2014
Second Affiliated Hospital & Yuying Children's Hospital of Wenzhou Medical University
2014
California Maritime Academy
2013
Ningbo University
2013
Shandong University of Technology
2010-2011
Bulk metallic glasses (BMGs) are usually brittle, and show serious negative strain rate sensitivity upon dynamic loading due to no sufficient time for generation of the shear bands, which fatally limit their practical applications. Investigations have been done on BMGs deformation behaviors, but in yielding phenomenon was hardly reported before. In this work, by raising stored energy appears as an exothermic heat relaxation heating glass, quasi-static behaviors Cu45.75Zr46.75Al6.5Co1 BMG...
Abstract In the present paper, crystallization behavior and glass forming ability (GFA) of Cu 64 Zr 36 bulk metallic (BMG) were studied based on crystal phase competition. Electrical resistivity X‐ray diffraction results indicate that underwent a two‐stage process, during which 10 7 51 14 crystals precipitate at first then there are only 8 3 phases end second stage. Intriguingly, it was found is competing weakens GFA alloy, because fully restrained in cast rod when substituting with 7.5at%Ti...
Abstract A sensitive and rapid ultra performance liquid chromatography tandem mass spectrometry (UPLC‐MS/MS) method was developed to determine voriconazole in human plasma. Sample preparation accomplished through a simple one‐step protein precipitation with methanol. Chromatographic separation carried out on an Acquity UPLC BEH C 18 column using isocratic mobile phase system composed of acetonitrile water containing 1% formic acid (45:55, v/v) at flow rate 0.50 mL/min. Mass spectrometric...
Abstract During the heating process temperature‐induced liquid–liquid structure transition (LLST) of Al 86 Ni 9 La 5 melt from 1320 to 1490 K was identified by both electrical resistivity and differential thermal analysis measurement. The effects liquid structural change on crystallization behavior glass forming ability (GFA) alloy were investigated. amorphous samples prepared at different temperatures according states obtained. results showed that formation intermetallic compounds during...
Abstract It is widely accepted that the structures and properties of solids are influenced greatly by its matrilineal liquid state. In present paper, correlation between internal friction behavior Zr 55 Al 10 Ni 5 Cu 30 BMG samples their quenching temperatures was investigated. The measured tan ϕ − T curves showed positions peaks did not change with frequencies for all samples. But they were shifted to higher temperature elevated. supercooled liquid, melt was, lower was. Based on theory...
To study the melt structural evolution, at different temperatures, electrical resistivity evolution patterns with time of Sn–Sb10 were experimentally investigated during isothermal processes. There was no change in process 850°C for 360 min, while higher i.e. 875°C, 885°C, and 900°C, there a dropping turn resistivity-time curves ranges. The temperature, earlier shorter range. As resort verified to be sensitive valid investigating liquid structure changes past studies, suggests occurrence...