Xiang Liu

ORCID: 0009-0002-8650-6370
Publications
Citations
Views
---
Saved
---
About
Contact & Profiles
Research Areas
  • Wastewater Treatment and Nitrogen Removal
  • Microbial Community Ecology and Physiology
  • Water Treatment and Disinfection
  • Aquatic Ecosystems and Phytoplankton Dynamics
  • Protist diversity and phylogeny
  • Marine and coastal ecosystems
  • Adaptive Control of Nonlinear Systems
  • Vibration and Dynamic Analysis
  • Soft Robotics and Applications
  • Machine Fault Diagnosis Techniques
  • Iterative Learning Control Systems
  • Adaptive Dynamic Programming Control
  • Simulation and Modeling Applications
  • Advanced Algorithms and Applications
  • Constructed Wetlands for Wastewater Treatment
  • Microbial Fuel Cells and Bioremediation
  • Oil and Gas Production Techniques
  • Piezoelectric Actuators and Control
  • Freshwater macroinvertebrate diversity and ecology
  • HVDC Systems and Fault Protection
  • Quantum Mechanics and Non-Hermitian Physics
  • Industrial Technology and Control Systems
  • Gut microbiota and health
  • High-Voltage Power Transmission Systems
  • Phosphorus and nutrient management

Xi'an University of Architecture and Technology
2020-2024

Shanghai University
2023-2024

Southwest Petroleum University
2023

China Southern Power Grid (China)
2022

China National Petroleum Corporation (China)
2022

Research Institute of Petroleum Exploration and Development
2022

Ministry of Transport
2022

Central South University
2022

Peking University
2021

Singapore University of Technology and Design
2020

Although many source waterbodies face nitrogen pollution problems, the lack of organic electron donors causes difficulties when aerobic denitrifying bacteria are used to treat micro-polluted water. Different forms iron with granular activated carbon (AC) as carriers were stimulate aboriginal microorganisms for purification Compared iron-absent AC system, targeted pollutants significantly removed (75.76% nitrate nitrogen, 95.90% total phosphorus, and 80.59% chemical oxygen demand) in...

10.1021/acs.est.1c05254 article EN Environmental Science & Technology 2022-03-03

The key limiting factors in the treatment of low C/N micropolluted water bodies are deficient essential electron donors for nitrogen removal processes. An iron/activated carbon aquagel (IACA) was synthesized as a slowly released inorganic donor to enhance aerobic denitrification performance treatment. efficiency IACA reactors enhanced by more than 56.72% and highest 94.12% accomplished compared with those control reactors. Moreover, CODMn improved 34.32% Illumina MiSeq sequencing consequence...

10.1021/acs.est.2c08770 article EN Environmental Science & Technology 2023-03-21

The coculture theory that promotes denitrification relies on effectively utilizing the resources of low-efficiency microbes. Here, strains Streptomyces sp. PYX97 and TSJ96 were isolated showed lower capacity when cultured individually. However, enhanced nitrogen removal (removed 96.40% total nitrogen) organic carbon reduction 92.13% dissolved carbon) under aerobic conditions. Nitrogen balance analysis indicated coculturing efficiency nitrate converted into gaseous reaching 70.42%. Meanwhile,...

10.1021/acs.est.3c05062 article EN Environmental Science & Technology 2023-12-15

In an actual engineering environment, some rotating machines are usually in normal operation, but their time a fault state is very short, which leads to serious imbalance the diagnosis datasets for machinery, and gives traditional network model shortcomings of poor stability low accuracy practical applications. To solve this problem, we propose method based on combination new Dual-stage Attention-based Recurrent Neural Network (DA-RNN) depth residual dispersion self-calibration convolution...

10.1109/access.2023.3264636 article EN cc-by-nc-nd IEEE Access 2023-01-01

Quality control is of vital importance during electronics production. As the methods producing electronic circuits improve, there an increasing chance solder defects assembling printed circuit board (PCB). Many technologies have been incorporated for inspecting failed soldering, such as X-ray imaging, optical and thermal imaging. With some advanced algorithms, new are expected to production quality based on digital images. However, current algorithms sometimes not accurate enough meet...

10.1109/indin45582.2020.9442142 article EN 2022 IEEE 20th International Conference on Industrial Informatics (INDIN) 2020-07-20

Model predictive current control (MPCC) has been proposed for the of a pulse width modulation (PWM) rectifier due to its simple principle and quick response. MPCC achieves good performance ideal grid voltages when an accurate inductance value is known. However, actual are usually unbalanced distorted, may vary with working condition. In these conditions, PWM deteriorates significantly harmonics power ripples. To cope distorted variations, this paper proposes model-free (MFPCC) rectifier,...

10.1109/ecce44975.2020.9236226 article EN 2022 IEEE Energy Conversion Congress and Exposition (ECCE) 2020-10-11
Coming Soon ...