A5115652998- Advancements in Battery Materials
- Enhanced Oil Recovery Techniques
- Advanced Battery Materials and Technologies
- Hydrocarbon exploration and reservoir analysis
- Advanced Battery Technologies Research
- Petroleum Processing and Analysis
- Microstructure and Mechanical Properties of Steels
- Scoliosis diagnosis and treatment
- Surgical Simulation and Training
- Silicon and Solar Cell Technologies
- Reliability and Maintenance Optimization
- Spinal Fractures and Fixation Techniques
- Spine and Intervertebral Disc Pathology
- Advancements in Semiconductor Devices and Circuit Design
- Reservoir Engineering and Simulation Methods
- Photonic and Optical Devices
- Smart Grid and Power Systems
- 3D IC and TSV technologies
- Electronic Packaging and Soldering Technologies
- Knee injuries and reconstruction techniques
- Sports injuries and prevention
- Seismic Performance and Analysis
- Hydraulic Fracturing and Reservoir Analysis
- Copper Interconnects and Reliability
- Prosthetics and Rehabilitation Robotics
Shanghai Jiao Tong University
2023-2025
Tianjin University
2023-2024
Hebei University of Technology
2024
Minzu University of China
2024
UCSF Benioff Children's Hospital
2023
University of California, San Francisco
2023
Sinopec (China)
2023
Beijing University of Technology
2012
The burgeoning development in industrial technology and the rapid evolution realm of new energy have precipitated an increasing need for dependable reliability assessment lithium-ion batteries. However, complexity time-varying degradation rates poses a significant challenge accurately predicting remaining useful life Additionally, acquisition high-quality battery data entails substantial time financial investments. Consequently, novel model that employs Neural representation-based Wiener...
Slickwater fracturing fluids are widely used in the development of unconventional oil and gas resources due to advantages low cost, formation damage high drag reduction performance. However, their performance is severely affected at temperatures. Drag reducing agent key determine slickwater. In this work, order further improve temperature resistance slickwater, a temperature-resistant polymeric (PDRA) was synthesized as basis for preparing The slickwater system prepared with compositions 0.2...
Hard carbon (HC) is widely used in sodium-ion batteries (SIBs), but its performance has always been limited by low initial Coulombic efficiency (ICE) and cycling stability. Cathode compensation agent a favorable strategy to make up for the loss of active sodium ions consumed HC anode. Yet it lacks that effectively decomposes increase as well regulate defects decreasing irreversible consumption. Here, we propose 1,2-dihydroxybenzene Na salt (NaDB) cathode with high specific capacity (347.9...
Prelithiating cathode is considered as one of the most promising lithium compensation strategies for practical high energy density batteries. Whereas reported agents are deficient owing to their poor air-stability, residual insulating solid, or formidable Li-extracting barrier. Here, this work proposes molecularly engineered 4-Fluoro-1,2-dihydroxybenzene Li salt (LiDF) with specific capacity (382.7 mAh g-1 ) and appropriate delithiation potential (3.6-4.2 V) an air-stable agent. More...
The plastic deformation of TWIP steel is greatly inhibited during the expansion process. stress–strain curves obtained through experiments and observations fracture morphology confirmed low behavior deformation. Through an analysis mechanical model, it was found that process has a lower stress coefficient faster strain rate than stretching, which inhibits plasticity Using metallographic microscopy, transmission electron EBSD to observe twin tensile deformation, higher density, manifested in...
Nanomaterials have been widely used in oilfields and attracted more attention. At present, the introduction of nanofluids plays an important role imbibition low-permeability reservoirs. However, interfacial activity is usually low. There are few studies on effect ultralow tension (IFT) nanofluid imbibition. In this work, with oil–water IFT 10–3 mN/m were screened. The core huff–puff static experiments carried out to study recovery. experimental results show that can make reach equilibrium...
Through Silicon Via (TSV) has emerged as a good solution to provide high density interconnections in three-dimensional packaging interconnect technologies. However, the thermal-mechanical reliability is big issue. When TSV subjected thermal load, large stress and strain would be created at interface of materials because great mismatch CTE. In this paper, an axi-symmetric single model with RDL layer taken into consideration. A static temperature difference Δt=165°C carried out simulate...