A5105509554- Particle physics theoretical and experimental studies
- High-Energy Particle Collisions Research
- Particle Detector Development and Performance
- Quantum Chromodynamics and Particle Interactions
- Dark Matter and Cosmic Phenomena
- Computational Physics and Python Applications
- Neutrino Physics Research
- Cosmology and Gravitation Theories
- Radiation Detection and Scintillator Technologies
- Medical Imaging Techniques and Applications
- Distributed and Parallel Computing Systems
- Atomic and Subatomic Physics Research
- Particle accelerators and beam dynamics
- Particle Accelerators and Free-Electron Lasers
- Astrophysics and Cosmic Phenomena
- Superconducting Materials and Applications
- Muon and positron interactions and applications
- CCD and CMOS Imaging Sensors
- Nuclear Physics and Applications
- Digital Radiography and Breast Imaging
- Black Holes and Theoretical Physics
- Spectroscopy and Laser Applications
- Advanced Data Storage Technologies
- Structural Analysis of Composite Materials
- Advanced Proteomics Techniques and Applications
Istituto Nazionale di Fisica Nucleare, Sezione di Pisa
2014-2025
Fermi National Accelerator Laboratory
2024
University of Chicago
2024
European Organization for Nuclear Research
1984-2024
University of California, Santa Cruz
2023-2024
Atlas Scientific (United States)
2024
A. Alikhanyan National Laboratory
2024
Pontificia Universidad Católica de Chile
2023-2024
The University of Adelaide
2019-2023
University of Pisa
2007-2018
The Cotton–Mouton constants of argon, krypton, and xenon have been measured relative to nitrogen at room temperature ambient pressure for λ = 514.5 nm. Upper limits helium neon determined. sensitivity the apparatus was Δnmin 0.8 × 10−14 a measuring time 1 sec.
The first measurement of the magnetic birefringence (Cotton–Mouton effect) in molecular hydrogen and deuterium has been performed. Cotton–Mouton constant H2 D2 measured at room temperature, atmospheric pressure, for λ=514.5 nm. Comparison with theoretical calculations shows very good agreement both cases.
The laser calibration system of the ATLAS Tile hadron calorimeter for LHC run II is presented. performances and monitor tools internal to are given in terms operation time stability. use normal procedures also described.
Abstract The central hadron calorimeter (TileCal) of the ATLAS experiment at Large Hadron Collider (LHC) is a sampling read out by about 10,000 photomultipliers (PMTs). Earlier studies performance showed degradation in PMTs response as function integrated anode charge. At end High-Luminosity LHC (HL-LHC) program, expected charge for reading most exposed cells 600 C, and their projected loss 25%. These (≈ 8% total TileCal PMTs) will be replaced with newer version PMT same geometry. A test...
The Tile Calorimeter (TileCal) is the hadronic calorimeter covering central region of ATLAS experiment. TileCal a sampling with steel as absorber and scintillators active medium. are read-out by wavelength shifting fibers coupled to photomultiplier tubes (PMTs). analogue signals from PMTs amplified, shaped, digitized signal every 25 ns stored on detector until trigger decision received. High-Luminosity phase LHC (HL-LHC) expected begin data taking in 2026 requires readout electronics...
We present the results of first measurement on yield pions with momentum smaller than 220 MeV/c, produced by a 300 GeV/c proton beam. The measurements, performed at CERN super synchrotron using tungsten production targets different lengths, are discussed referring to possibility extending high-energy laboratories access fundamental research involving low-energy and muons.