A5064971132- Innovative Teaching Methods
- Experimental Learning in Engineering
- Technology-Enhanced Education Studies
- Climate Change and Health Impacts
- Healthcare and Environmental Waste Management
- Higher Education Teaching and Evaluation
- Conservation Techniques and Studies
- Online and Blended Learning
- Advanced Sensor and Energy Harvesting Materials
- Higher Education Governance and Development
- Educational Technology in Learning
- Educational Innovations and Technology
- Building materials and conservation
- Digital literacy in education
- Conducting polymers and applications
- Ionic liquids properties and applications
- Mechatronics Education and Applications
- Higher Education Learning Practices
- Medical Device Sterilization and Disinfection
- E-Learning and Knowledge Management
- Educational Innovations and Challenges
- Educational Technology and Assessment
- Engine and Fuel Emissions
- Socioeconomic Development in MENA
- Dielectric materials and actuators
Universitat Politècnica de València
2016-2025
Instituto de Salud Carlos III
2023-2024
Biomedical Research Networking Center in Bioengineering, Biomaterials and Nanomedicine
2023
GI endoscopy units represent the third largest producers of medical waste. We aimed to determine endoscopic instrument composition and life cycle assessment (LCA) assess a sustainability proposal based on mark instruments that identifies parts can be safely recycled or 'green mark'.Material analysis LCA forceps, snares clips from four different manufacturers (A-D) were performed with methods. Carbon footprint production, transportation end these was calculated. In 30 consecutive procedures,...
Infection outbreaks associated with contaminated reusable duodenoscopes (RUDs) have induced the development of novel single-use (SUDs). This study aimed to analyze material composition and life cycle assessment (LCA) RUDs SUDs assess sustainability global partial SUD implementation.
This paper shows the data of Flip Teaching and Traditional Methodology on laboratory practice in two subjects, Physics Electricity, a technical degree. The final grades these subjects were shown four consecutive years. characteristics all years quite similar, except that teaching (TM) was used two, while methodology (FT) applied other two. For further discussion, please refer to scientific article entitled "Effectiveness flip engineering students' performance physics lab" [1]. Additional...
The electroactive characteristics of poly(vinylidene fluoride) (PVDF) are widely and increasingly being used in technological applications, where controlling the crystallization PVDF is utmost importance. nucleation growth crystals β or γ phases, nonelectroactive α phase, depends on a number factors that, despite studies carried out, still to be properly understood, particular, when blended with specific active fillers. In this context, ionic liquid (IL) 1-ethyl-3-methylimidazolium...
Aims Carbon footprint analysis using life cycle assessment (LCA) has become more frequent in GI endoscopy. Various methods are available. To compare carbon emissions obtained through open access databases with an approach professional software.
In order to tailor dielectric response and electrical conductivity, novel polymer blends based on poly(vinylidene fluoride (PVDF) different fillers composed by poly(3,4-ethylenedioxythiophene):poly(styrene sulfonate) (PEDOT:PSS), PEDOT:PSS/ionic liquids (ILs): PEDOT:PSS/N-ethyl-N-methylpyrrolidinium bis(fluorosulfonyl)imide ([C2mpyr][FSI]) bis(trifluoromethanesulfonyl)imide ([C2mpyr][TFSI]), with PEDOT:PSS/IL contents (10, 20 40 wt%) were prepared through solvent casting. The morphological,...
Ironically, healthcare systems are key agents in respiratory-related diseases and estimated deaths because of the high impact their greenhouse gas emissions, along with industry, transportation, housing. Based on safety requirements, hospitals related services use an extensive number consumables, most which end up incinerated at life cycle. A thorough assessment carbon footprint such devices typically requires knowing precise information about manufacturing process, is rarely available...
The combination of poly (vinylidene fluoride) (PVDF) with ionic liquids (ILs) is increasingly being studied for the development smart materials. Together functional response provided by IL, its incorporation into PVDF allows to nucleate specific electroactive phases polymer, depending on processing conditions. Thus, isothermal crystallization incorporating different contents magnetic liquid bis(1-ethyl-3-methylimidazolium) tetrathiocyanatocobaltate ([Emim]2 [Co(SCN)4]) reported in this work....
Aims GI endoscopy is highly resource-intensive with a significant environmental impact and extensive utilization of non-reusable plastic instruments. Colonoscopy the most commonly performed gastrointestinal procedure. The type material has direct effect on carbon emission. We aimed to scrutinize materials employed in colonoscopy procedures, assessing their life cycle (LCA) by determining footprint.
The influence of the inclusion organic solvent propylene carbonate (PC) in microporous membranes based on poly(l-lactic acid) (PLLA) and poly(vinylidene fluoride-co-hexafluoropropylene) P(VDF-HFP) has been studied its relevance for application those separator lithium-ion batteries. have produced through casting characterized with respect to swelling ratio originated by uptake solvent. affects porous microstructure crystalline phase both membrane types. amount crystal size as a consequence...
I. Tort-AusinaM.A. Serrano JareñoJ.A. Gómez-TejedorJ. Riera GuaspA. Vidaurre GarayoJ. Molina-MateoM.A. Gámiz GonzálezJ.M. Meseguer-Dueñas
STUDENTS' OPINION ABOUT A TEACHING MODEL BASED ON TEAM WORK, CONTINUOUS FORMATIVE EVALUATION AND FLIP ORGANIZED THROUGH AN E-LEARNING PLATFORM
In this work, we analyzed the reliability and discriminatory capability of BEMA (Brief Electricity Magnetism Assessment) for students Physics courses in Engineering Degrees taught at School Design (ETSID) from Universitat Politècnica de València (UPV).BEMA is a 30-item multiple-choice test designed to assess understanding basic electricity magnetism concepts.The questions are mostly qualitative some them require simple calculations.The useful when combines validity, capability.The validity...
Appears in: EDULEARN16 Proceedings Publication year: 2016Pages: 8117-8127ISBN: 978-84-608-8860-4ISSN: 2340-1117doi: 10.21125/edulearn.2016.0779Conference name: 8th International Conference on Education and New Learning TechnologiesDates: 4-6 July, 2016Location: Barcelona, Spain
A. Vidaurre GarayoJ.M. Meseguer-DueñasJ. Molina-MateoI. Tort-AusinaJ. Riera GuaspM.A. Gámiz GonzálezR. Martínez Sala
A. Vidaurre GarayoJ.A. Gómez-TejedorR. Martínez-SalaJ.M. Meseguer-DueñasJ. Molina-MateoS. Quiles-CasadoM.A. SerranoI. Tort-AusinaJ. Riera
PERFORMANCE ANALYSIS BY BEMA OF ELECTRICITY AND MAGNETISM COURSES IN ENGINEERING DEGREES USING FLIP TEACHING METHODOLOGIES
J.M. Meseguer-Dueñas, S. Quiles, R. Sabater I Serra, M.A. Serrano, J.A. Gómez-Tejedor, T. García Sánchez, I. Tort-Ausina, J. Molina-Mateo, Gámiz-González, Riera, A. VidaurreUniversitat Politècnica de València (SPAIN)