A5063542380- Supercapacitor Materials and Fabrication
- Conducting polymers and applications
- Energetic Materials and Combustion
- Thermal and Kinetic Analysis
- Graphene research and applications
- Luminescence Properties of Advanced Materials
- Carbon Nanotubes in Composites
- Advancements in Battery Materials
- Electrocatalysts for Energy Conversion
- Mass Spectrometry Techniques and Applications
- Radiation Detection and Scintillator Technologies
- Aerogels and thermal insulation
- Nuclear Physics and Applications
- Atomic and Molecular Physics
- Diamond and Carbon-based Materials Research
- Electrochemical sensors and biosensors
- Combustion and Detonation Processes
- Catalytic Processes in Materials Science
- Advanced Sensor and Energy Harvesting Materials
- Electric Power Systems and Control
- Laser-Ablation Synthesis of Nanoparticles
- Ion-surface interactions and analysis
- Nanomaterials for catalytic reactions
- Gas Sensing Nanomaterials and Sensors
- Nuclear physics research studies
Russian Academy of Sciences
2010-2019
Federal Research Centre Coal and Coal Chemistry
2014-2017
Kuzbass State Technical University
2017
Institute of Coal of the Siberian Branch of the RAS
2014
Institute of Coal Chemistry
2014
Institute of Coal Chemistry and Material Science
2014
Institute of Solid State Chemistry and Mechanochemistry
2010
Kemerovo State University
2009-2010
Joint Institute for Nuclear Research
1995
Au/C nanocomposites have been obtained by the ultrasonic assisted reduction of HAuCl4 solutions, impregnated in carbon material pores, using NaBH4 as a reducing agent. It was established that conditions nanocomposite (NC) synthesis exert an essential influence on shape and size characteristics Au filler functional properties NCs. Characterization NCs X-ray diffraction, small-angle scattering, cyclic voltammetry methods has revealed increase concentration raises not only gold nanoparticle...
Carbon nanotubes are widely employed as catalyst supports and electrode materials. In our earlier studies, capacitance characteristics of carbon (CNTs) nitrogen-doped (N-CNTs) were measured. Voltammetric curves obtained for in an acid electrolyte showed pseudocapacitance peaks that caused by electrochemical processes involving nitrogen-containing functional groups. this study, measurements made a two-electrode cell supercapacitor with hydrophilic polypropylene PORP-A1 film serving separator...
<p>Nickel hydroxide was deposited on the surface of porous carbon to obtain a cathode material for supercapacitors. This work is first part study Ni(OH)<sub>2</sub>/С composite, which considers conditions its synthesis using two types matrices with highly developed specific area (1000–3000 m<sup>2</sup>/g) and precursors (NiCl<sub>2</sub>*6H<sub>2</sub>O Ni(N<sub>3</sub>)<sub>2</sub>). The morphology systems, in...
Composites of the type “nitrogen-containing carbon coating – single-walled nanotubes” were obtained by treatment nanotubes (SWCNT) in a gaseous 40%NH3-1%C2H2-C2H4 mixture at temperatures 600–750 °C. Single-walled etched aqua regia (SWCNTet) and doped with nitrogen (N-SWCNT) studied XPS, electron microscopy IR spectroscopy. Various oxygen-containing functional groups found to reside on surface initial SWCNTet. Upon SWCNTet 40%NH3-1%С2Н2-C2H4, polymerization condensation hydrocarbons resulted...
The paper shows the possibility of increasing capacity characteristics composite electrodes Ni(OH) 2/C, synthesized on basis a highly porous carbon material (HPCM). It is known that introduction 2 in materials results increased capacity.