A5025130826- Advanced Photocatalysis Techniques
- TiO2 Photocatalysis and Solar Cells
- Catalytic Processes in Materials Science
- Copper-based nanomaterials and applications
- Archaeology and ancient environmental studies
- Electronic and Structural Properties of Oxides
- Gas Sensing Nanomaterials and Sensors
- Fluid Dynamics and Turbulent Flows
- Advanced Nanomaterials in Catalysis
- Biosensors and Analytical Detection
- Marine and environmental studies
- Heat Transfer Mechanisms
- Aerodynamics and Acoustics in Jet Flows
- Archaeological Research and Protection
- Cultural Heritage Materials Analysis
- Maritime and Coastal Archaeology
- Image Processing and 3D Reconstruction
University of Salento
2019-2022
Istituto Nazionale di Fisica Nucleare, Sezione di Lecce
2020
Abstract In recent years, the exploitation of natural resources and industrial development have led to production harmful pollutants. Much these contaminants end up in water resources, reducing availability drinking water. Therefore, it is necessary find remedies this situation. Solutions could be adsorption or degradation through photocatalysis compounds. A good candidate for task titanium dioxide (TiO 2 ), due its non-toxicity, stability low cost. work, we propose a novel synthesis TiO...
Intensive use of antibiotics induced adaptations in bacteria, which developed antibiotic resistance. This is becoming a serious health problem, particularly the hospital, food industry, or public transport. It also important to produce surfaces that not only are bactericidal but prevent adhesion and consequent biofilm formation, can make bacteria resistant conventional disinfection methods. In this work, simple inexpensive method obtain TiO 2 film coated has been realized attachment...
We reports a study on pure and Ni-doped TiO2 thin films produced via laser ablation technique. The novelty of the work consists that both synthesis doping were carried out in single process, using modified ion source to simultaneously make pulsed deposition (PLD) low-energy implantation (by post-acceleration method). In particular, two titania synthesized PLD starting from rutile target. One was doped with Ni ions, accelerated voltage 20 kV. total implanted dose, evaluated by Faraday cup,...
Herein, a study on the photocatalysis and antibacterial performances of Cu‐doped titania films as function dopant concentration is presented. The TiO 2 are produced by sol–gel spin‐coating technique, doping performed adding different quantities copper in form salt (CuSO 4 ) during preparation sol. obtained characterized Raman X‐ray diffraction spectroscopies, atomic force microscopy, Rutherford backscattering spectrometry, to investigate chemical–physical properties, quality, composition,...