Haoxiang Zhang

ORCID: 0000-0003-0311-5746
Publications
Citations
Views
---
Saved
---
About
Contact & Profiles
Research Areas
  • GaN-based semiconductor devices and materials
  • Electric and Hybrid Vehicle Technologies
  • Ga2O3 and related materials
  • Advanced Battery Technologies Research
  • Hydraulic and Pneumatic Systems
  • Electric Vehicles and Infrastructure
  • Real-time simulation and control systems
  • ZnO doping and properties
  • Semiconductor materials and devices
  • Process Optimization and Integration
  • Metal and Thin Film Mechanics
  • Advanced Control Systems Optimization
  • Mesoporous Materials and Catalysis
  • Catalysis and Oxidation Reactions
  • Hybrid Renewable Energy Systems
  • Membrane Separation Technologies
  • Advanced Optical Sensing Technologies
  • Microgrid Control and Optimization
  • Zeolite Catalysis and Synthesis
  • Catalytic Processes in Materials Science
  • Invertebrate Immune Response Mechanisms
  • Gas Sensing Nanomaterials and Sensors
  • CCD and CMOS Imaging Sensors
  • Microstructure and Mechanical Properties of Steels
  • Iron and Steelmaking Processes

Anhui Agricultural University
2025

Fujian Medical University
2025

Union Hospital
2025

Zhejiang University
1999-2024

Ningbo University of Technology
2024

Ministry of Industry and Information Technology
2024

Green Energy Engineering Consultancy (China)
2023

Geely (China)
2023

Communication University of Zhejiang
2022

Chung-Ang University
2021-2022

The effects of GaN channel layer thickness on dc and RF performance AlGaN/GaN high-electron mobility transistors (HEMTs) with a state-of-the-art composite (1/1 μm) buffer were systematically investigated. Although HEMTs thick exhibit slight degraded small-signal associated short-channel effects, they demonstrate significantly enhanced OFF-state breakdown voltage large-signal performance. 1-mm 150-nm-thick feature 1.4 dB higher saturated POUT about 10% PAE than that 50-nm-thick layer, in both...

10.1109/ted.2014.2312232 article EN IEEE Transactions on Electron Devices 2014-04-03

Low-pressure chemical vapor deposition (LPCVD) technique is utilized for SiN <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">x</sub> passivation of AlGaN/GaN high-electron-mobility transistors (HEMTs). A robust / AlGaN interface featuring high thermal stability and well-ordered crystalline structure achieved by a processing strategy “passivation-prior-to-ohmic” in HEMTs fabrication. Effective suppression surface-trap-induced current collapse...

10.1109/led.2015.2432039 article EN IEEE Electron Device Letters 2015-05-12

Single-nozzle based multimaterial direct ink writing enables voxel-based fabrication with superior printing efficiency than multi-nozzle protocol. This is attractive for food 3D process where matters its application. However, single-nozzle process, the presence of residual material in shared channel can affect fidelity. In this study, we propose a path planning algorithm that address issue by incorporating (i) advance distance to compensate extrusion delay when switching materials, and (ii)...

10.1080/17452759.2024.2352075 article EN cc-by Virtual and Physical Prototyping 2024-05-21

Since that setting frequency signal as an agent can provide the distributed generations (DGs) with opportunities to adaptively maintain supply and demand balance, a new energy management strategy modified droop control for islanded microgrid containing photovoltaic (PV)/battery/fuel cell (FC)-eletrolyser is proposed in this study. Without communication line or central supervisor, three power sources operate mode PV units track offer maximum order make full use of energy, battery regulate...

10.1049/iet-pel.2015.0663 article EN IET Power Electronics 2016-03-07

A heat pump is applied in pressure-swing distillation (PSD) for separating an isobutanol/isobutyl acetate mixture this paper. To ensure dry compression and prevent compressor damage, a preheater added before the based on fluid property of mixture. In addition, optimal preheated temperature overhead vapor stream may further improve performance pump-assisted PSD process. Through optimization analysis, optimum superheat values streams from two columns are 12 8.4 °C, respectively. The...

10.1021/acs.iecr.9b06918 article EN Industrial & Engineering Chemistry Research 2020-02-07

This study evaluated Al-ZSM-5 nanocrystals grown from silicalite-1 seed crystals as catalysts for the methane dehydroaromatization (MDA) reaction. Silicalite-1 sized between 30 and 40 nm were used to grow under various synthesis conditions. The size of was significantly affected by Si/Al ratio (SAR), time, silica nutrients/seed crystal (NSR). Larger obtained with an increased SAR in sols. Gradual growth occurred although ceased at 5 h 120 °C, indicating rapid aided seeds. Precise tuning...

10.3390/en14020485 article EN cc-by Energies 2021-01-18

Low cost stainless steels (SS) with high performance, especially good mechanical properties and oxidation resistance at temperature, are continuous pursuit for manufacture industry. To achieve combination of properties, cost, nanoprecipitate strengthened alumina forming austenitic (NSAFA) SS have been developed by removing expensive elements such as Nb Ta, lowering Ni concentration in Fe-26Ni-15Cr-1.5Mo-(2.8-3.5)Al-(1-2.35)Ti (wt.%) alloys. Microstructure investigation demonstrates that...

10.1016/j.jmrt.2024.05.056 article EN cc-by-nc Journal of Materials Research and Technology 2024-05-01

Red-green-blue white light-emitting diodes (RGB-WLEDs) have great potential as commercial solid-state lighting devices, well visible light communication because of their high color-rendering index (CRI) and response frequency. The quality an RGB-WLED strongly depends on its spectral parameters. In this study, we fabricated RGB-WLEDs with red, blue, green LEDs measured the power distribution (SPD). experimental SPD is consistent calculated spectrum. We also SPDs different peak wavelengths...

10.1364/ao.55.004456 article EN Applied Optics 2016-05-31

Polyvinyl alcohol (PVA)/CNT composite membranes were prepared without adding cross-linkers; herein, carboxylated CNTs served as alternative cross-linkers. A molecular simulation confirmed the cross-linking capability between and PVA chains, which led to prediction that cross-linked PVA/CNT complex would be stable in water. To realize simulated outcome, multiwalled activated functionalized via sonication methods subsequent acid treatment. The membranes, including treated by probe sonication,...

10.1021/acssuschemeng.1c06715 article EN ACS Sustainable Chemistry & Engineering 2022-01-06

An increasing number of monitoring systems have been developed in smart cities to ensure that a city's real-time operations satisfy safety and performance requirements. However, many existing city requirements are written English with missing, inaccurate, or ambiguous information. There is high demand for assisting policy makers converting human-specified machine-understandable formal specifications systems. To tackle this limitation, we build CitySpec, the first intelligent assistant system...

10.1109/smartcomp55677.2022.00020 preprint EN 2022-06-01

A single crystalline GaN film on Si(111) with a buffer layer is grown by simple reactive evaporation method. Scanning electron microscopy, x-ray diffraction (XRD), transmission microscopy (TEM), photoluminescence measurement (PL), and Hall results indicate that the wurtzite was successfully microcrystalline layers substrate. The surface of films mirror-like crack-free. pronounced (0002) peak appears in XRD pattern. full width at half maximum (FWHM) double-crystal rocking curve for from...

10.1063/1.372264 article EN Journal of Applied Physics 2000-03-15

Three-dimensional NAND flash memory featuring dozens of vertically stacked cells is the state-of-the-art technology for most storage platforms. To fabricate three-dimensional (3D) memory, lateral etching Si3N4 layer over SiO2 an essential step that conducted through a wet process using phosphoric acid-based etchant. Silyl-phosphate or highly selective nitride serves as solution additive to control dissolution rate. However, silyl-phosphate prepared with expensive monomeric silica precursor...

10.1021/acssuschemeng.0c05677 article EN ACS Sustainable Chemistry & Engineering 2021-04-01

A hydraulic hybrid powertrain for passenger vehicle is studied in this paper. The consists of a hydro-mechanical transmission and accumulator. key component pressure-controlled transmission. It combines pumping motoring function one unit potentially more competitive terms both energy efficiency cost effectiveness than conventional hydrostatic By feeding the output flow to variable displacement motor coupled shaft, compact simpler constituted. In paper systematic approach applying studied....

10.1115/fpmc2017-4353 article EN 2017-10-16

The steady-state characteristics of a power split hydraulic transmission were carefully studied in this article. is an alternative device for hybrid drivetrain. It was built from balanced vane pump, where output shaft added and coupled to its floating ring. internal friction torques due the relative motion between ring vanes help drive shaft. This improves mechanical transfer efficiency input shaft, making it more competitive than conventional hydrostatic transmission. investigated through...

10.1109/tmech.2020.3001363 article EN IEEE/ASME Transactions on Mechatronics 2020-01-01
Coming Soon ...