A5101727138- Perovskite Materials and Applications
- Electrocatalysts for Energy Conversion
- Dark Matter and Cosmic Phenomena
- Particle Detector Development and Performance
- Astrophysics and Cosmic Phenomena
- Catalytic Processes in Materials Science
- Solid-state spectroscopy and crystallography
- Advancements in Battery Materials
- Supercapacitor Materials and Fabrication
- Gas Sensing Nanomaterials and Sensors
- Advanced Fiber Optic Sensors
- Advanced Battery Materials and Technologies
- Multiferroics and related materials
- Advanced Measurement and Metrology Techniques
- 2D Materials and Applications
- Urban Heat Island Mitigation
- Geotechnical Engineering and Soil Stabilization
- Metal Alloys Wear and Properties
- Dielectric materials and actuators
- Engineering Structural Analysis Methods
- Electrochemical sensors and biosensors
- Mechanical Failure Analysis and Simulation
- Intermetallics and Advanced Alloy Properties
- Thermal Radiation and Cooling Technologies
- Advanced materials and composites
Zhengzhou University of Light Industry
2019-2024
Collaborative Innovation Center of Advanced Microstructures
2022-2024
Nanjing University
2020-2024
Soochow University
2024
Hunan Institute of Science and Technology
2024
Zhejiang University of Technology
2024
Chongqing University of Technology
2024
Yibin University
2024
Huazhong University of Science and Technology
2007-2024
City University of Hong Kong
2023-2024
Although 2D materials are widely explored for data storage and neuromorphic computing, the construction of material-based memory devices with optoelectronic responsivity in short-wave infrared (SWIR) region in-sensor reservoir computing (RC) at optical communication band still remains a big challenge. In this work, an electronic/optoelectronic device enabled by tellurium-based van der Waals (vdW) heterostructure is reported, where ferroelectric CuInP2 S6 tellurium channel endow both...
The currently available materials cannot meet the requirements of human thermal comfort against hot and cold seasonal temperature fluctuations. In this study, a dual-mode Janus film with bonded interface to gain functions both highly efficient radiative cooling solar heating for year-round management is designed prepared. side achieved by embedding NaH
By the introduction of Mo 4/3 B 2− x T z nanosheets, NiFeLDH/Mo /NF (nickel foam) shows an improved OER performance compared with NiFeLDH/NF owing to rich active sites and excellent conductivity .
Porcine reproductive and respiratory syndrome (PRRS) is an economically important disease of swine that caused by PRRS virus (PRRSV). In this study, we established a fluorescence assay for highly sensitive detection PRRSV through integration the reverse transcription–recombinase polymerase amplification (RT-RPA)-coupled Cas12a system with optical property single stranded DNA–fluorescently quenched (ssDNA-FQ) reporter. This technique can achieve isothermal visual in 25 min. particular,...
Camera networks are essential to constructing fast and accurate mapping between virtual physical space for digital twin. In this paper, with the aim of developing energy-efficient twin in 6G, we investigate real-time video analytics based on cameras mounted mobile devices edge coordination. This problem is challenging because 1) limited battery life lightweight computation capability, 2) captured frames continuous changing, which makes corresponding tasks arrival uncertain. To achieve twin,...
The instability of perovskite optoelectronic devices remains a big barrier to their commercialization. caused by external stimuli has been addressed encapsulation, such as humidity, oxygen, heat, and ultraviolet light. However, the intrinsic materials due lattice strain not fully addressed, which affects physical properties device performance great extent. Tuning controlling composition ratio is an effective way further develop efficient stable devices. Herein, we prepare series...
The surface roughness of wood mortise and tenon seriously influence the strength mortise-and-tenon joints. However, it is difficult to obtain whole due limitation in measuring range most profilometers. Therefore, selection measured position critical tenon. This study mainly aimed investigate effects thickness direction (T1, T2, T3) length (L1, L2, L3), assembly condition (unassembled assembled) on characterize their roughness. Roughness profile results showed that average (4.53 µm) was...
Abstract Sulfur dioxide (SO 2 ) and carbon (CO removals are of great significance for fossil fuel combustion, where they can be simultaneously captured by calcium‐based absorbents. Nevertheless, the CO uptake capacity declines with SO partial pressures. This paper aims at explaining mechanisms steam‐declined sulfation steam‐enhanced carbonation density functional theory calculations. CaO(001) surface is chosen as absorbent, transition state calculated to obtain desorption barrier energy...
Dielectric behavior was compared experimentally between polyethylene terephthalate (PET) and poly(ethylene 2,6-naphthalate) (PEN). Due to their similar chemical structures, the two polymers exhibit many parallel dielectric properties. While fairly thermally stimulated polarization depolarization currents (TSPC TSDC), temperature at which TSPC or TSDC starts increase rapidly is about 20°C higher in PEN than PET, mostly likely reflecting difference glass transition temperatures (T <sub...
MnS has been explored as an anode material for lithium-ion batteries due to its high theoretical capacity, but low electronic conductivity and severe volume change induce reversible capacity poor cycling performance. In this work, the nanocapsule consisting of nanopolyhedrons confined in independent, closed conductive hollow polyhedral nanospheres is prepared by embedding MnCO3 into ZIF-67, followed coating RF resin gaseous sulfurization/carbonization. Benefiting from unique structure,...
Radiative cooling fabrics have gained significant attention for their ability to enhance comfort without consuming extra energy. Nevertheless, sweat accumulation on the skin and diminishing efficiency usually exist in reported polymer membranes. Herein, we report a universal method obtain calcium (Ca)-salt-enhanced fiber membrane with high infrared emission hydrophilicity efficient passive flame retardancy. The modification by Ca salts (including CaSiO3, CaSO3, CaHPO4) strong results an...