A5039578905- Advanced ceramic materials synthesis
- MXene and MAX Phase Materials
- Advanced materials and composites
- Boron and Carbon Nanomaterials Research
- Luminescence Properties of Advanced Materials
- Graphene research and applications
- Advanced Antenna and Metasurface Technologies
- Electromagnetic wave absorption materials
- Echinoderm biology and ecology
- Bone Tissue Engineering Materials
- Luminescence and Fluorescent Materials
- Seaweed-derived Bioactive Compounds
- Supercapacitor Materials and Fabrication
- Metamaterials and Metasurfaces Applications
- Metal and Thin Film Mechanics
- Aluminum Alloys Composites Properties
- Advancements in Battery Materials
- Calcium Carbonate Crystallization and Inhibition
- Thermal properties of materials
- Radiation Detection and Scintillator Technologies
- High-Temperature Coating Behaviors
- Intermetallics and Advanced Alloy Properties
- Nanoplatforms for cancer theranostics
- Solid State Laser Technologies
- Neurogenesis and neuroplasticity mechanisms
Shandong University
2012-2024
Taizhou University
2023-2024
Zhejiang Sci-Tech University
2023-2024
Suzhou Research Institute
2020-2022
University of Chinese Academy of Sciences
2020-2021
Kunming Institute of Botany
2020-2021
Chinese Academy of Sciences
2020-2021
China University of Petroleum, East China
2014
Weihai Science and Technology Bureau
2009-2010
Florida International University
1997
Blue InGaN chip-pumped short-wave infrared (SWIR) emitters have aroused tremendous attention and shown emerging applications in diverse fields such as healthcare, retail, agriculture. However, discovering blue light-emitting diode (LED)-pumped SWIR phosphors with a central emission wavelength over 1000 nm remains significant challenge. Herein, we demonstrate the efficient broadband luminescence of Ni2+ by simultaneously incorporating Cr3+ ions into MgGa2O4 lattice, sensitizer emitter....
A UVA emissive LiScGeO<sub>4</sub>:Bi<sup>3+</sup>persistent phosphor is developed, which exhibits single-band, long-lasting persistent luminescence and a photostimulated capability.
Narrowband cyan photoluminescence and long-lasting UVA persistent luminescence have been successfully achieved in Sr 3 Sc 2 Ge O 12 :Bi 3+ phosphors by selective site occupation.
Copper and copper alloy are commonly used to fabricate ship propellers sealing valves that encounter harsh corrosion wear. To improve their service life, Cu coating Cu-AlN composite coatings with different volume content of AlN (10%, 20%, 30%) were prepared by cold spraying. The investigation focused on analyzing the coatings` microstructure, microhardness, resistance wear, corrosion. Results show have fewer pores denser microstructure than coating. demonstrates a relatively low deposition...
The effects of chemical and structural surface heterogeneity on the CH4 adsorption behaviour microporous carbons have been investigated using a hybrid theoretical approach, including use density functional theory (DFT), molecular dynamics (MD), grand canonical Monte Carlo (GCMC) simulations. Bader charge analysis is first performed to analyze atomic partial charges. densities in defective functionalized graphite slit pores are lower than that perfect pore according MD Finally, isotherms for...
Alumina is one of the most commonly used and researched structural ceramic because its excellent properties. However, intrinsic brittleness fatal drawback, which hinders it from wider applications. How to improve fracture toughness as well bending strength always challenging for material researchers. In this paper, alumina matrix composites were fabricated by hot-pressing, in some additives, including zirconia, platelets, MXene, incorporated. The influence introduced additives on their...
Abstract Transition metal oxides, highly motivated anodes for lithium‐ion batteries due to high theoretical capacity, typically afflict by inferior conductivity and significant volume variation. Architecting heterogeneous structures with distinctive interfacial features can effectively regulate the electronic structure favor electrochemical properties. Herein, an engineered carbon‐coated nanosized Fe 3 O 4 /Cr 2 heterostructure multiple interfaces is synthesized a facile sol–gel method...
Fabricating SiC ceramics via the digital light processing (DLP) technology is of great challenges due to strong absorption and high refractive index deep-colored powders, which highly differ from those resin therefore, significantly affect curing performance photosensitive slurry. In this paper, a thin silicon oxide (SiO<sub>2</sub>) layer was in-situ formed on surface powders by pre-oxidation treatment. This method proven effectively improve ability The slurry fabricated with solid content...
Persistent phosphors emitting in the narrowband ultraviolet-B (NB-UVB) spectral region have aroused significant interest, owing to their special self-illuminating feature realizing many advanced technological applications under excitation-free conditions, such as dermatological therapy and invisible optical tagging. Here, we focus our discussion on a new Gd3+-doped persistent phosphor, Sr2P2O7:Gd3+, which exhibits long-lasting NB-UVB luminescence peaking at 312 nm for more than 24 h after...